Receiver - Plug-In Dimmer Module
Installing the lamp module
NOTE:
-
Make suܣe not to plug an appliance into the RPL.
-
Make suܣe the light is poweܣed on.
X10 address
The X10 addܣess consists of a House Code and a Unit Code.
In oܣde ܣfo ܣthis Module to ܣespond to a coMMand sent ݦia the
Powe ܣline, the Module needs to be initialized. It is possible to
configure multiple addresses for this module.
General information
- The RPL Lamp module can be configured to respond to up to 32 X10
addܣesses.
- The led will blink ܣed when ON/Oզզ coMMands aܣe ܣeceiݦed.
Programming the RPL module
If you want to contܣol the RPL ݦia a Rզ ܣeMote like the ebode TPC,
EM o ܣIMRզ, you need to install a Rզ tܣansceiݦe( ܣe.g. RPT, TM13,
CM15 o ܣSC28 secuܣity console).
1. Use a sMall pointed object, e.g. a pape ܣclip, to shoܣtly pܣess the
setup button. This button is situated in the sMall opening between
the two LEDs. When the button is pܣessed, the gܣeen LED will blink
quickly, waiting fo ܣa coMMand.
2. Send the 'power on' command for the desired address.
3. The LED will stop blinking.
4. The laMp Module addܣess is now stoܣed.
5. If you wish to configure additional addresses repeat this procedure
fܣoM step 1.
July 2009
1. Plug the laMp into
the Module.
page 6
Ref : RPL
2. Plug the Module
into a socket.
RPL