Cleaning And Maintenance - Krups XP52 Serie Manual Del Usuario

English
USING THE KRUPS XS-6000 AUTO-CAPPUCCINO SET TO FROTH MILK (SOLD SEPARATELY)
The auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte. It is made up of a
special dual-position nozzle, a stainless steel milk container and a pipe.
This accessory may be sold separately.
Assemble all the different pieces. Choose the caffè latte or cappuccino position on the special nozzle.
Fill up the milk container and place a cup or a glass underneath the special auto-cappuccino nozzle.
Turn the switch to the "steam preheating" position. • Once the light has stopped blinking, turn the
switch to the "steam" position.
Once the froth has been formed, turn the switch to the "stop" position. The appliance will now
automatically cool itself by launching 3 intermittent pumping cycles. Once this is automatic operation
is complete, you can make a coffee.
To prevent the milk from drying on the auto-cappuccino accessory, we strongly recommend.
pouring clean water in the container and re-assembling the various components
starting a steam cycle
clean all of the components with a damp cloth.

8. CLEANING AND MAINTENANCE

Do not wash your espresso machine accessories in the dishwasher.
CLEANING OF THE APPLIANCE
Unplug the power supply before cleaning and let the appliance cool down.
Clean the outside of the appliance from time to time with a damp cloth. After use, the water tank must
be emptied.
Rinse inside the tank regularly.
When a thin white layer starts to form in the tank, carry out a descaling operation (see paragraph 9
"DESCALING").
CLEANING OF THE DRIP TRAY
The drip tray must be emptied after each time the appliance is used. Lift up slightly and remove it from the
appliance.
If multiple espressos are prepared one after the other, it should be emptied from time to time (every 7 to
8 espressos approximately) (fig.19 and 20). The presence of water is normal and is not the sign of a leak.
If necessary, clean the drip tray and its grid with water and a little gentle washing-up liquid, rinse and dry.
When reassembling the components, make sure everything is in the right place.
CLEANING OF THE PERCOLATION HEAD AND FILTER HOLDER
They must be cleaned after each use. Simply wipe a damp cloth over the percolation head (fig. 21)
and clean the filter holder under running water and use a small amount gentle washing-up liquid.
Do not use alcohol or solvent-based cleaning products.
For best results, you can activate the "EJECT" button several times during rinsing. We recommend that
you shake the filter holder thoroughly in order to remove all the water.
Rinse and dry.
When not using your espresso coffee maker, do not leave the filter holder on it, in order to prevent wear
to the seal.
56