Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. Fasten end of each shelf piece to the leg brace of
the outside legs with six M8 x 35 hex bolts and six
M8 nuts per shelf using a 13 mm wrench. (See Figure 6)
M8 x 35
Hex Bolts
TOP ASSEMBLY
1. To attach tabletop (10) onto frame assembly, place
tabletop on a smooth, non-marring surface with top
side facing down.
2. Rotate assembled frame upside down and line up
two pre-drilled holes on back corners of table top.
Do not insert screws into these two holes and the two
holes in front of them at this time. (See Figure 7)
Do Not Insert
Figure 7
Do Not
Insert Screws
Pre-drilled
Holes
3. Using all other hole locations in frame as a template,
drill 3/4" deep pilot holes into tabletop using a 3/16"
drill bit. Using 14 (16 for 72" table) wood screws and
a drill with a Phillips head drill bit, attach frame to
underside of tabletop in these new pilot holes.
(See Figure 8)
Figure 8
Wood
Screw
PAGE 3 OF 27
ASSEMBLY CONTINUED
Screws
Pre-drilled
Holes
Front
Tabletop
Wood Screw
Front
Tabletop
NOTE: Additional pre-drilled holes in tabletop
are used for a different product and will not
align with this frame. You must pre-drill your
own pilot holes.
NOTE: Wood screws for front and back of frame
are optional but provide more support.
4. Using a 1/4" drill bit, drill four holes all the way
through tabletop in hole locations shown in Figure 9.
They should line up with holes in back of leg.
Figure 6
(See Figure 9)
NOTE: These will be used to attach uprights later.
Figure 9
5. Carefully set table upright and recheck all screws for
tightness.
6. Place two storage shelf support brackets (6) onto
inside of outside legs (2) with lip side facing down
and inside frame. Fasten each support bracket to
legs with two M10 x 65 hex bolts and two M10 nuts
using a 17 mm wrench. (See Figure 10)
Figure 10
M10 x 65 Bolt
and M10 Nut
NOTE: 4" high storage shelf is a two-piece
design. One end of each piece rests on top
of the storage shelf support bracket. The other
end will bolt to the center leg's middle brace.
7.
Slide the end of each shelf piece on top of the
storage shelf support bracket. Have two people hold
up the end of the shelves that face the center leg
and align the holes on the side of the shelf pieces
to the holes in the center leg's middle brace. Fasten
shelf pieces to center leg's middle brace with three
M8 x 65 hex bolts and three M8 nuts using a
13 mm wrench. (See Figure 11)
Back
Support Bracket
Storage Shelf
Top Not Shown
0521 IH-8226
Publicidad
Tabla de contenido
