Configuration - Phoenix Contact EMpro EEM-MA600 Instrucciones De Montaje

1. Pushbuttons with dual functionality:
Normal mode: Display measured values
Programming mode: Change configuration
2. Backlit LCD
3. Display for the measured values in relevant conductor
4. Measured value
5. Unit
6. Current measurement as a % bar indicator
7. Frequency display
8. Alarm relay 1 (if installed)
9. Alarm relay 2 (if installed)
10. Display for the energy
11. Display for active communication (if optional communication module is installed)
12. Display for recording the real energy (flashes for every kWh)
5.2

Configuration

Once the device has been installed and connected, it can be configured.
Figure 12 Switching to configuration mode
Button Description
PROG Opening configuration mode (press and hold for 3 seconds)
▲ or ▼ Selection of the next menu item
▶ Opening edit mode
◀ or ▶ In edit mode: selection of the parameters/values to be changed
▲ or ▼ In edit mode: changing the parameters/values
OK Confirm setting
To exit configuration mode, hold down the "PROG" button for 3 seconds.
The corresponding configuration menu is displayed for the extension/communication module used. For the
necessary configuration settings, please refer to the corresponding user manual for the measuring device, at
phoenixcontact.net/products.
104513_en_03
1 x
3 seconds
English
PHOENIX CONTACT 9