jbc DI 3000 Manual Del Usuario página 3

DI 3000 digital control unit
- DI 3000 230V
- DI 3000 120V
- DI 3000 100V
This unit allows you to connect 2 tools, work
with one tool and have the other tool in its
stand at "sleep" temperature.
To switch just place back one tool in its stand
and take out the other.
All soldering handpieces and hot tweezers of our
JBC range can be used with the DI 3000 always
using the corresponding stand.
Technical specifications
- Temperature selection from 90 to 450°C or
190 to 840°F (±5%).
- Power: 75W.
- Safety transformer, mains separator and
double isolation, with integrated temperature
protection fuse.
- DI 3000 230V control unit
Input: 230V 50Hz. Output: 24V.
- DI 3000 120V control unit
Input: 120V 60Hz. Output: 24V.
- DI 3000 100V control unit
Input: 100V 60Hz. Output: 24V.
- Total weight of unit: 2,5Kg (6,25lbs).
- ESD protected housing "skin effect".
Typical surface resistance: 10
square.
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- RoHS compliant.
- Equipotential connector and the tool tip are
connected to station mains ground supply for
ESD protection.
This product should not be thrown in the
garbage.
INTRODUCING JBC TECHNOLOGY
The exclusive JBC heating system achieves an
Ref. 3000200
exceptional thermal recovery, which increases
Ref. 3000100
productivity, quality, reduces cost of ownership
Ref. 3000109
and ensures fast return on investment.
Unequalled thermal response
An excellent soldering tool features instant thermal
response conceived by a high power/mass ratio.
A high power/mass ratio is being used to maintain
the tip's temperature as close as possible to the
one selected on the control unit, even when the
thermal load is significant. This is the formula
needed to perform high quality solderjoints and
avoid cold ones, protect the PCB that is being
soldered and increase productivity.
INTELLIGENT HEAT MANAGEMENT
The only time that a soldering tool should be at
working temperature is when it is actually being
used. JBC stations identify if and how a tool is
being used and depending on this switches the
Ref. 3000200
tool to one of the following modes with their
respective temperatures:
Ref. 3000100
Work mode: selected working temperature i.e.
350°C.
Ref. 3000109
Sleep mode: during short periods of inactivity
the tool's temperature is being lowered to an
intermediate temperature i.e. 220°C.
Hibernation mode: During larger periods of
5 11
-10 Ohms/
inactivity i.e. 30 minutes, the tool's power is being
cut off and it cools down to room temperature.
The advantages of this heat management are
significantly increased catridge lifespan and
substantial energy savings which ensures low
cost of ownership.
JBC Tools save money by managing Heat
efficiently saving energy, time and improving
processes.
If you would like to change the SLEEP and
HIBERNATION parameters, as any other
function, see page 11.
You will find all the information about control unit
DI 3000 in the following link:
http://www.jbc.es/english/catalog
JBC reserves the right to make technical changes without prior
notification.
2
ENGLISH