Westfalia 304112600001 Instrucciones De Montaje página 2

SIARR
01 - 94
PREPARATION
* Remove the gravel flap located under the bumper.
ASSEMBLY
* Fasten (without tightening) arms A and B under the longitudinals
at the points marked X, using fastening kit X.
* Position the lateral retainers D and E to the points marked V and W
using fastening kits V and W.
* Fasten the tow bar body C to the points marked W using fastening kit W.
FINISHING
* Tighten all of the nuts, bolts and screws to the torques indicated below.
* On the gravel flap, trace, then cut the holes
as per the sketch.
* Refit the gravel flap.
FASTENING KIT
2 off HM10x30 screws
V
2 off CS10 washers
4 off HM12x45 screws
W
4 off CS12 washers
4 off HM12 nuts
4 off HM10x30 screws
X
4 off CS10 washers
4 off 10/25 plain washers
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
2 off HM12x90 screws
Y
2 off HM12 nuts
2 off CS12 washers
2 off HM16x45 screws
Z
2 off HM16 nuts
2 off DEC16 washers
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM0194-F - FOLIO NDMANG
Type Type
Approval No.
SI009
Tow bar for
Citroën C5 estate e24*94/20*00*0033
Phase II (Std)
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
304112600001
Cut to be made
Max. Total Max. Total Max. Verti-
Authori. Weight Towable Weight
cal load
2 175 kg 1 500 kg
Pre-existing notches
to be removed
Value
D
85 kg 8,70 kN