Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: For optimum performance of this product, we recommend
a system pressure between 20 and 80 PSI static. This product
will operate up to a maximum of 125 PSI static per ASME and CSA
requirements. However, we do not recommend pressure above
80 PSI. Thermal expansion or leaking pressure reducing valves
may require use of expansion tanks or relief valves to ensure your
system never exceeds its maximum intended pressure setting.
NOTE: Not for use as an anti-ligature device.
PLEASE LEAVE this M&I Sheet with the owner, maintenance plumber, etc. as
items relating to ongoing maintenance suggestions and procedures are included.
061263A
Anchor Plate
Truss Screw
(12/pkg)
063217A
Anchor Plate
O-Ring (12/pkg)
Hardware
supplied
by others
063196A -
063213A -
063214A -
WALLMOUNT SHOWERHEAD
w w w . s p e c s e l e c t . c o m
Page 1
1.5 GPM (5.7 L/min)
1.75 GPM (6.6 L/min)
2.0 GPM (7.5 L/min)
COMPLETE
063216A
Hold down Screw
with O-Ring (12/pkg)
063215A
Anchor Plate
& SS Screws
210290 Rev. A
Publicidad
Tabla de contenido
Manuales relacionados para Delta 063196A
Resumen de contenidos para Delta 063196A
- Página 1 063196A - 1.5 GPM (5.7 L/min) 063213A - 1.75 GPM (6.6 L/min) 063214A - 2.0 GPM (7.5 L/min) NOTE: For optimum performance of this product, we recommend WALLMOUNT SHOWERHEAD a system pressure between 20 and 80 PSI static. This product...
-
Página 2: Installation Instructions
Installation should be in accordance with local plumbing and electrical codes. FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. INSTALLATION INSTRUCTIONS Fig. 1 TYPICAL INSTALLATION 1956 mm 1956 mm (77.0”) (77.0”) Recommended Recommended Mounting Mounting Height Height FINISHED FLOOR FINISHED FLOOR All items shown by dotted lines supplied by others 19 mm (Ø... - Página 3 Installation should be in accordance with local plumbing and electrical codes. FLUSH ALL PIPES THOROUGHLY BEFORE INSTALLATION. INSTALLATION INSTRUCTIONS STEP 1 - ROUGH IN (Piping & Anchor Plate) ● Rough-in 1/2” (12.7 mm) copper piping to shower Fig. 2 head as recommended in Fig. 1. It is suggested +6.3mm (1/4”) to flush copper tube to install the showerhead on a smooth flat Must be cut off (deburr OD &...
-
Página 4: Ensemble Complet De Pomme De Douche Murale
063196A - 1,5 gal/min (5,7 L/min) 063213A - 1,75 gal/min (6,6 L/min) 063214A - 2,0 gal/min (7,5 L/min) REMARQUE : Pour un rendement optimal, nous recommandons une ENSEMBLE COMPLET DE pression de système entre 20 et 80 psi statiques. Ce produit fonc- tionne à... -
Página 5: Installation Typique
L’installation doit être faite conformément avec les codes locaux de plomberie et d’électricité. DRAINEZ BIEN TOUS LES TUYAUX AVANT L’INSTALLATION. CONSIGNES D’INSTALLATION Fig. 1 INSTALLATION TYPIQUE 1956 mm 1956 mm (77,0”) (77,0”) Hauteur de Hauteur de montage montage recommandée recommandée SOL FINI SOL FINI Tous les articles fournis par d’autres... - Página 6 L’installation doit être faite conformément avec les codes locaux de plomberie et d’électricité. DRAINEZ BIEN TOUS LES TUYAUX AVANT L’INSTALLATION. CONSIGNES D’INSTALLATION ÉTAPE 1 - ROBINETTERIE BRUTE (tuyauterie et plaque de support) ● Raccordez la pomme de douche avec une tuyau- Fig.
- Página 7 Delta Commercial Faucet Limited Warranty All parts of the Delta® HDF® and TECK® faucets are warranted to the original consumer purchaser to be free from defects in material, finish and workmanship for a period of five (5) years unless otherwise specifically stated in the catalogue and price book. This warranty is made to the original consumer purchaser and shall be effective from date of purchase as shown on purchaser’s receipt.