Initializing The Hdcc-02; Extra Settings - Axxess HDCC-02 Manual De Instrucciones

Initializing the HDCC-02

Attention! If the interface loses power for any reason, the following steps will need
to be performed again. Also, if installing an ASWC-1 connect it after you initialize
and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the
radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the
off position, disconnect the interface, check all connections, reconnect the
interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all
functions of the installation for proper operation, before reassembling the dash.

Extra settings

LaneWatch settings:
Note: The LaneWatch button is located on the left side of the steering wheel,
on the stalk.
• Press and hold the LaneWatch button for 15 seconds to toggle right turn signal
triggering on or off. If on, press and hold the button again for 15 seconds to
toggle it off. Likewise if off. The hi-beam indicator will flash 1 time if off; 2 times
if on.
Note: Right turn signal triggering is default on.
HDCC-02
Extra settings
CAUTION!
The following step should only be performed by an authorized Honda
technician. Once this procedure has been started, you cannot back out of it
• Press and hold the LaneWatch button for 50 seconds to begin the LaneWatch
aiming procedure. The hi-beam indicator will flash 3 times. At this point
the display will also show an image of the LaneWatch camera feed, with
instructions on what to do--a Honda authorized technician will know what to do
from here.
Note: While accessing LaneWatch aiming the right turn signal triggering will be
toggled after 15 seconds has passed, so the hi-beam indicator will flash before the
50 second mark is reached. The technician will have to ignore that and continue
holding the button until the 50 second mark is reached to aim the camera.
Clock and date settings:
Note: This section refers to the buttons on the left side of the steering wheel.
Note: If no button is pressed for 15 seconds, this process will end.
• Activate the analog clock on the top screen.
• Press and hold the "Source" button for 15 seconds until the hi-beam indicator
blinks twice, and then let go.
• Press and release the "Seek-Up" and "Seek-Down" buttons to toggle between
minutes, hours, days, months, and year.
• Once a choice is selected, press and release the "Volume-Up" or "Volume-
Down" buttons to adjust the settings.
• While changing the hour, press the "Source" button to toggle between 12 and
24 hour formats.
• Wait 15 seconds for the process to end.
3
(cont.)
.