Battery Information - Doro BM35 Manual De Instrucciones

Baby Unit ( )
1. Connect the baby unit's mains adapter to the mains wall socket.
2. Set the control on the unit's right side in position 1.
3. Adjust sensitivity using the control on the back (A=least sensitive....H=most sensitive)
by talking quietly into the baby unit at the same time as someone else listens to the
parent unit.
Please note!
The parent unit must be charged for 24 hours before it is used for the first time.
The recharging system used in this model may result in it becoming warm. This is normal and will not
damage the equipment.
Do not place the baby or parent units close to other electrical equipment such as computers, computer
screens, telecom equipment, fans, etc. This is to minimize the risk of any interference. Do not place the
units in places where they will be exposed to direct sunlight or other major heat sources!
Only use original batteries in the parent unit. The guarantee does not cover any damage caused by
incorrect batteries.

Battery Information

The symbol in the display indicates when it is time to recharge the battery. When
|
the battery is running low, the indicator will flash.
On the parent unit the sections are turned off one by one as the power goes down.
Fully-charged batteries (14 hours charging) will last for approx. 48 hours of normal use
or approx. 2 hours of continuous transmission.
These operation times apply at normal room temperature. Because batteries only have a
certain lifespan it is quite normal that operating time will decrease somewhat compared
to the specifications when the baby monitor is used regularly.
English