Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Key Beep (Parent Unit)
The sound heard when you press the buttons can be switched on or off here.
Press w repeatedly until
1.
Scroll to the desired setting using
2.
Press
.
3.
PTT
Channel Lock (Parent Unit)
This function locks the channels and the volume on the parent unit to prevent
unintentional usage of some buttons (
Press
until the display shows the key symbol.
1.
N
Cancel the key lock by holding
2.
Turning the Parent Unit On/Off
Press and hold the
Sound activation / adjustable sensitivity (VOX) Baby Unit
By using the VOX sensitivity adjustment you are able to select the level of sound
transmitted from the baby unit to the parent unit. This is useful to filter normal or quite
sounds 'in the room' but still hear important or crying noises to suit your preference.
Test different settings for sensitivity for the most effective use:
A = Least Sensitive H = Most Sensitive.
Safety Signal (Baby Unit)
Using this function, a beep is sent every 30 seconds (in standby) from the baby monitor
so that you know that the right channel/sub channel has been set and that the range
has not been exceeded. The display shows Beep when the function is active.
Press MENU repeatedly until Beep is displayed.
1.
Scroll to the desired setting using
2.
Wait a few seconds until the display returns to standby mode.
3.
Automatic Monitoring (Baby Unit)
You can activate a function that monitors for five seconds every five minutes.
The display shows Auto Mon when the function is active.
Press MENU repeatedly until Auto Mon is displayed.
1.
Scroll to the desired setting using
2.
Wait a few seconds until the display returns to standby mode.
3.
Activity Signal (Baby Unit)
The activity signal is an additional aid to get your attention when sounds are heard in
the vicinity of the baby unit. This function sends a tone sequence to the parent unit
when the baby unit is activated (ie. by the baby crying).
The display shows
Press MENU repeatedly until
1.
Scroll to the desired setting using
2.
Turning the Baby Unit On/Off
Use the control on the right side of the baby unit to turn it on/off.
is displayed.
to
N
button for a few seconds to turn the parent unit on or off.
1
when the function is activated.
Ca
English
/
(
=off,
v
V
OF
On
and
/
).
w
v
V
pressed until the symbol in the display disappears.
/
(
=off,
v
V
OF
On
/
(
=off,
v
V
OF
On
and
are shown.
/
(
=off,
v
V
OF
On
=on).
=on).
=on).
=on).
Publicidad
Tabla de contenido
