Monitor Function - Doro BM35 Manual De Instrucciones

Versions with Multiple Parent Units (+1, +2 etc.)
With two or more parent units (referred to as handsets below) this product can be used
as a walkie talkie as well. The following description explains how two handsets can
communicate with each other. It is also possible to use one of the handsets as a baby unit
which means that more than one child can be monitored at the same time, see Page 7.
To communicate
Make sure that you use the same channel and sub channel, see Page 3.
1.
Press and hold
2.
If nobody answers, send a ring signal by pressing
3.
Please note!
If the handsets are unable to communicate it may be because you are using different channels or sub
channels, the battery is running low or the handsets are too far apart.
Paging
You can scan all channels to locate one that is transmitting. If a signal is found, the
display shows the channel number and the signal is heard for a few seconds.
Press PTT to stop at the right channel.
During searching, battery power consumption is significantly higher than normal.
Press and
1.
w
v
Disconnect the function by pressing
2.

Monitor function

If the signal is weak, the monitor function can be used.
Press for at least five seconds.
1.
Disconnect the function by pressing
2.
Sound Activation
This unit can be used without having to press the PTT button to transmit. By setting
the correct level, the equipment can determine in an instant whether you are speaking
or if the sound level in the room is normal.
Test different settings for sensitivity. Even with a very accurate setting, there is
unfortunately always a slight risk that noise from the surroundings may activate the
transmitter, or that the first word won't be heard completely. The latter problem can be
solved by calling out the name before every message.
The transmitting function is shut off two seconds after you have finished speaking.
The display shows VOX when the function is active. If the handset transmits by itself,
i.e. it is set too sensitively, press
setting.
Press repeatedly until
1.
w
Scroll to the desired setting using
2.
( =off, 1=least sensitive....3=most sensitive).
OF
Press .
3. PTT
(Push To Talk) while you speak.
PTT
at the same time. The display starts searching among the channels.
(VOX)
to be able to interrupt temporarily to change the
w
is displayed.
VOX
English
.
.
w
.
PTT
/ .
v V