Recommended Installation Position In Your Car; Charging - Anycom Manual Del Usuario

ANYCOM Solar Car-Kit

3. Recommended Installation Position in Your Car

It is recommended that the ANYCOM Solar Car-Kit is positioned and installed on to the top of the left side of the windshield as shown in the picture below
(The ANYCOM Solar Car-Kit can be installed using either 3M tapes or suction cups).
Installing the ANYCOM Solar Car-Kit in the recommended position will lead to more efficient solar power charging and better performance with regard to the
microphone. Ensure that the Car-Kit does not obstruct the driver's view.

4. Charging

1. Using the car charger
•
Open the cover on the charging port and insert the car charger completely into the charging slot until the battery status LED glows red.
•
Charge your ANYCOM Solar Car-Kit until the battery status LED turns off. The unit will be fully charged in approximately 2 hours.
2. Using solar power
•
Direct the solar panel on the back side of ANYCOM Solar Car-Kit toward sun (please refer to the recommended installation position, as
mentioned above).
•
If the ANYCOM Solar Car-Kit receives sufficient sunlight for 3 h, you can talk for duration of up to 30 min. When using solar power charge,
the operation time (the talk time and the standby time) will be extended continuously without any additional charge required by the car
charger.
•
By pressing
detailed instruction.
Do not attempt to charge the hands-free car kit with any charger other than the one provided.
! WARNING:
Using another charger may damage or destroy the product.
www.anycom.com
for 5 s, the solar power charging status is indicated. Please refer to the Solar power charging status below for the
Page 4
English