Electrical Safety - Black and Decker GT524 Manual Del Usuario

ENGLISH

Electrical safety

This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
Additional safety instructions for hedgetrimmers
Wear safety glasses or goggles when operating this
tool.
Wear gloves when operating this tool.
Wear ear protection when operating this tool.
Immediately disconnect the cable from the mains if
it is damaged or cut.
Do not expose the tool to rain or high humidity.
Keep the cable away from the blades while using this
tool.
If you have not used a hedgetrimmer before, preferably
seek practical instruction by an experienced user in
addition to studying this manual.
Never touch the blades while the tool is running.
Never attempt to force the blades to come to a standstill.
Do not put the tool down until the blades have come to a
complete standstill.
Regularly check the blades for damage and wear. Do not
use the tool when the blades are worn or damaged.
Take care to avoid hard objects (e.g. metal wire, railings)
when trimming. Should you accidentally hit any such
object, immediately switch the tool off, unplug it and
check for any damage.
Should the tool start to vibrate abnormally, immediately
switch it off and check for any damage.
If the tool stalls, immediately switch it off. Unplug the
tool before attempting to remove any obstructions.
After use, place the blade sheath supplied over the
blades. Store the tool, making sure that the blade is not
exposed.
Always ensure that all handles and guards are fitted
when using the tool. Never attempt to use an incomplete
tool or a tool with unauthorised modifications.
Never allow children to use the tool.
When operating the extending handle, hold the unit away
from your body and loose clothes.
Be aware of falling debris when cutting the higher sides
of a hedge.
4
Additional safety instructions for Australia and
New Zealand
This appliance is not intended for use by young or infirm
persons without supervision. Children must be supervised
to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Handle switch
2. Trigger switch
3. Extending handle
4. Front handle release buttons
5. Rear handle release buttons
6. Blade
7. Blade sheath
This hedgetrimmer has the following features for your benefit:
Dual action blades for reduced vibration.
Laser cut and diamond ground blades for improved
cutting.
Extending handle for cutting the higher sides of hedges.
Use
Changing the position of the extending handle
Warning! Before changing the position of the extending
handle, make sure that the tool is switched off and unplugged.
Rotating the handle into the extended position
(fig. A1 & A2)
Your hedgetrimmer will reach you with the handle in the
forward position. To move the handle into the extended
position, proceed as follows:
Support the underside of the unit with one hand.
Simultaneously press the front handle release buttons (4)
with your thumb and middle finger and rotate the handle
(3) backward with your other hand.
Move the handle fully into the extended position. Make
sure the handle clicks and locks into place.
Rotating the handle into the forward position (fig. B1 & B2)
To move the handle from the extended into the forward
position, proceed as follows:
Support the underside of the unit with one hand.
Simultaneously press the rear handle release buttons (5)
with the thumb and index finger of your other hand and
rotate the handle (3) forward. As you move the handle out
of the extended position you will hear a click.
Move the handle fully into the forward position.