Air Frying - Russell Hobbs 22100-56 Manual De Instrucciones

AIR FRYING

1. Unplug your Cyclofry plus.
2. Place the items to be fried into the drum. Don't overfill the drum. Allow enough space for air to circulate and the ingredients to move freely (fig A).
3. Fit the lid onto the drum (fig. B).
4. Insert the drive shaft into the opening in the bowl (fig. C).
5. Lower the drum down until the two holes in the handles fit over the two pins in the body of the fryer (fig. D). The lid won't close unless the pins
pass through the holes in the handle.
6. Plug in your Cyclofry plus. The unit will beep and the display will light up briefly.
7. Tap the power button (C).
8. The display will light up showing the available programs.
9. Tap the air fry button ( ) button to select the air fry program.
10. The display will alternate between showing the default air fry temperature and the program run time (see DISPLAY). You can change either of these
settings (see PROGRAM GUIDE).
11. Change the settings as desired or accept the defaults. Tap the power button (C) to start the program.
12. Once the program has finished, the display will go out (except the power button) and the fan will operate for 20 seconds. After 20 seconds, your
Cyclofry plus will beep 5 times and then switch off.
Removing the drum
1. Open the lid. Beware of any escaping steam and hot air. Wear oven gloves or similar.
2. Use the two handles to remove the drum. We recommend using oven gloves because the drum and surrounding areas will be HOT.
3. Press the drum away from you (towards the rear of the unit) then lift the end of the drum that is nearest to you slightly upwards until it clears the
rim of the bowl.
4. Lift the drum clear of the bowl and place it down onto a heat resistant surface.
5. Press down the larger (triangular) release tab and carefully lift the lid off the drum (Fig. H). You don't have to press both release tabs to remove the
lid.
GRILLING
The grilling function is perfect for grilling, crisping or browning foods. Use as you would a conventional grill by bringing the food close to the heat
using the rack.
1. Unplug your Cyclofry plus.
2. Place the rack in the bowl. Use it in the high position.
3. Plug in your Cyclofry plus. The unit will beep and the display will light up briefly.
4. Tap the power button (C).
5. The display will light up showing the available programs.
6. Tap the grill button ( ) to select the grill program.
7. The display will alternate between showing the default grill temperature and the program run time (see DISPLAY). You can change either of these
settings (see PROGRAM GUIDE).
8. Change the settings as desired or accept the defaults.
9. Tap the power button (C) to start the program.
10. Once the program has finished, the display will go out (except the power button) and the fan will operate for 20 seconds. After 20 seconds, your
Cyclofry plus will beep 5 times and then switch off.
11. Open the lid. Beware of any escaping steam and hot air.
12. You can use the tongs to carefully remove the rack. We recommend you wear oven gloves.
• The program can be paused at any time by opening the lid. Close the lid to resume the program.
• To stop the program, press the power button (C). The program will stop and the fan will continue to run for 20 seconds. Any program settings will
be lost.
ROASTING/BAKING
1. Unplug your Cyclofry plus.
2. Place the rack in the bowl. Use it in the low position. Food can also be baked directly in the bowl (e.g. cakes).
3. The food can be placed directly onto the rack or into a suitably sized oven-proof container.
4. Plug in your Cyclofry plus. The unit will beep and the display will light up briefly.
5. Tap the power button (C).
6. The display will light up showing the available programs.
7. Tap the roast/bake button (
8. The display will alternate between showing the default roasting/baking temperature and the program run time (see DISPLAY). You can change
either of these settings (see PROGRAM GUIDE).
9. Change the settings as desired or accept the defaults.
10. Tap the power button (C) to start the program.
11. Once the program has finished, the display will go out (except the power button) and the fan will operate for 20 seconds. After 20 seconds, your
Cyclofry plus will beep 5 times and then switch off.
12. Open the lid. Beware of any escaping steam and hot air.
13. You can use the tongs to carefully remove the rack. We recommend you wear oven gloves.
• The program can be paused at any time by opening the lid. Close the lid to resume the program.
• To stop the program, press the power button (C). The program will stop and the fan will continue to run for 20 seconds. Any program settings will
be lost.
) to select the roast/bake program.
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE