Using The Control Panel - Lagrange GLACONS EXPRESS Manual Del Usuario

beFore using the aPPLianCe ________________
Before first use, ensure that the appliance has been left for 12
hours on a flat surface without any connection.
Make sure to always maintain the appliance in a horizontal
position when moving it, otherwise there is a risk of damaging
the compressor. Otherwise, wait for 12 hours before restarting
the appliance.
Commissioning and use ___________________
1 use
st
While unpacking the appliance, make sure that you remove all
wedging elements.
Make sure that all parts and accessories are present and without
defect.
Before using the appliance, clean all the parts properly (see
maintenance section).
Before every operation, check properly that your appliance is
disconnected. When the appliance is turned on, the "small size
ice cube" indicator lamp flashes. This means that the appliance is
awaiting instructions.

using the ControL PaneL

By default, the ice cube size selected will be the
smallest one.
You can select the size of ice cubes by successively
pressing the SELECTION button. A green indicator
lamp lights up above the corresponding illustration.
Note: The SELECTION button is inactive when the appliance is
operating and throughout its entire duration.
Once the size of ice cubes is selected, production
can be started by pressing the START button. The
production of ice cubes can then be stopped at
any time by pressing the STOP button.
When the ice tray is full, the indicator lamp turns
red.
Then, empty the ice-bucket and replace it.
The red indicator lamp goes off as soon as there is
space in the tray.
The appliance will then automatically produce new
ice cubes.
41