Lagrange GLACONS EXPRESS Manual Del Usuario página 44

step 4: removing the ice-cubes
After about 1h30 of production, the tray is filled with ice-cubes.
The "tray full" indicator lamp then turns red and the appliance
stops the production. The ice-cubes are kept cool in the appliance
but will nevertheless start melting.
Therefore, empty the ice-tray quickly, either to use the ice-cubes
immediately, or to refrigerate them in the freezer before the next
use.
step 5: Continuing production
If you wish to have a larger quantity of ice-cubes, and therefore
continue the production of ice cubes, re-insert the empty tray. The
"tray full" indicator lamp goes off and the production restarts.
step 6: depletion of water in the tank
After about 2h to 2h 30 of use (depending on the ice cube size
selected), the appliance would have exhausted the water in the
tank. The "lack of water" indicator lamp turns red as there is no
longer sufficient water to restart a cycle. If you wish to have a larger
quantity of ice-cubes, and therefore continue the production of
ice cubes, remove the tray and fill the tank with water without
exceeding the maximum level. The "lack of water" indicator lamp
goes off and the production restarts.
step 7: stopping production
When the quantity of ice-cubes obtained is sufficient, the
production may be stopped by pressing the STOP button. Remove
the ice-tray to collect the last ice-cubes produced.
step 8: draining the appliance
If there is any water left in the appliance once the production is
over, it may be drained. To do this, move the appliance closer to
the edge of the table. Turn it around so that it stands on three legs
and the drainage button is accessible. Remove the plug then place
a container under the plug. Remove the small white seal to enable
the water to flow. When the water stops flowing, replace the seal,
then the plug and push the appliance back on the counter before
putting it away.
43