HoMedics HG-2-2EU Manual De Instrucciones página 5

HM7658 HG-2-2EU_IB.qxd:Layout 1
INSTRUCTIONS FOR USE:
Changing Attachments
ALWAYS ensure the appliance is switched off before changing any
attachments. To change the attachments, simply twist off
(anti-clockwise) the massage head that is attached to the unit and
twist on (clockwise) the desired head. (See Figure 1)
Massage Function
NOTE: Always ensure the appliance is set to the 'OFF' before
inserting the plug into a mains outlet.
1. Plug the appliance into a 230V mains outlet and switch on.
2. Slide the power switch upwards to start the massage. Slide up one (I) position for low
intensity setting and two (II) positions for high intensity setting. The Hydragel™ neck will
illuminate blue to indicate your selection.
3. Apply the massager head lightly to the area you wish to treat. Move the unit slowly, holding it
over the targeted area. Treat the area for a short period of time and move to another area.
NEVER treat the same area for longer than 3 minutes.
4. To turn the unit off, slide the power switch downwards to the 'OFF' position.
Heat Function
1. Attach the Infrared heat massage head as described in the 'Changing Attachments'
section above.
2. First activate the massage function as described above. Then slide the 'Heat' switch upwards
to active the heat. Allow a few minutes for the heat to fully activate. The Hydragel™ neck will
illuminate red to indicate your selection.
3. To turn the heat off, slide the switch downwards to the 'OFF' position.
NOTE:
• To eliminate risk of being burned, only use the heat function with the Infrared heat attachment.
• The Heat function will only work when the massager is in use.
• DO NOT use the massage or heat functions continuously for more than 20 minutes.
• DO NOT use the massager directly on one concentrated area of the body. Massagers are
designed to be used in a continuous motion, constantly changing the massage area.
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly
damp sponge.
• Never allow water or any other liquids to come into contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact with
sharp edges or pointed objects which might cut or puncture the fabric
surface. To avoid breakage, DO NOT wrap the power cord around
the appliance. DO NOT hang the unit by the cord.
Plug (MODEL FM-100H-2GB ONLY)
If the plug on this appliance is damaged, it can be replaced
with a BS 1363 plug, fitted with a 3A BS 1362 fuse. Only use
a 3amp fuse with this appliance.
Care must be taken when changing the plug.
If in doubt, contact a qualified electrician.
25/1/07 18:53 Page 5
5
(Figure 1)