Technical Specifications - Bertazzoni F60 Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28

Technical Specifications

If the appliance does not work, inform Technical
Service of the kind of problem you are experi-
encing and give the:
1 Serial Number (S-No)
2 Model of Appliance (Mod.),
which you will find engraved on the identifica-
tion plate. This plate is located on the bottom of
the oven and can be seen when opening the
door.
Installation
This information is exclusively for the installer
who is responsible for assembly and electrical
connection. If you install the oven yourself, the
manufacturer will not accept liability for possi-
ble damage.
Prior to Installation
To unpack the oven, pull on the tab located at
the bottom of the box and hold it by the side
handles, never by the oven door handle.
The installation instructions must be adhered
to strictly. If not, the oven's ventilation circuit
may become blocked, causing high tempera-
tures that could damage the kitchen unit and
the appliance itself.
The opening in the kitchen unit must be that
indicated in Figures 8, 9 and 10, depending
on the type of installation. The minimum size
of the unit base must be 580 mm.
The rear of the unit, corresponding to the
shaded area (A) in Figure 11 must have noth-
ing projecting from it (unit reinforcement,
pipes, sockets, etc.).
The unit material, including covering materi-
als and glue must be able to withstand tem-
peratures of 120 ºC.
Electrical Connection
The installer must ensure that:
The mains power voltage and frequency cor-
respond to what is marked on the identifica-
tion plate.
The domestic wiring system can withstand
the maximum power marked on the identifi-
cation plate.
After connecting the power, check that all
electrical parts of the oven are working cor-
rectly.
Oven Installation
After connecting the power to the oven:
1 Position the oven inside the unit and ensure
that the power cable is not trapped or in con-
tact with parts of the oven that heat up.
2 Position the oven at the centre of the unit so
that there is a separation of at least 5 mm
between the oven and the adjacent units.
Figures 13 and 14.
3 Anchor the oven to the unit with the two
screws supplied, screwing them into the unit
through the two holes that can be seen when
the door is open.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido