Uline H-6521 Guia De Inicio Rapido página 2

1. After removing the heater from its carton, carefully
inspect it for possible shipping damage. Return
damaged units to Uline Customer Service.
2. Remove one plastic support leg and thermostat
knob from packaging in bottom of heater. The right
hand support leg is pre-assembled to the power
cord and requires only to be snapped into place.
(See Figure 1)
3. Fit left hand support leg onto heater and snap into
position. (See Figure 1)
4. Position thermostat knob onto thermostat shaft.
(See Figure 1)
NOTE: The knob will only fit onto shaft in one way.
IMPORTANT! This heater is a major electrical
appliance and requires adequate electrical
power. The outlet in use must be a 120 volt
circuit protected by a 15 or 20 amp fuse or
circuit breaker. No other major electrical
appliance should be operated in the same
circuit as the heater.
Use care when choosing the location and
using the heater. Do not block the heater in
any way to prevent air to flow freely through
the heater. Keeping the heater clean will also
improve the efficiency and prevent
overheating. See Maintenance on page 3 for
cleaning information.
WARNING! The heater plug must fit tightly into
outlet. A loose fitting or worn outlet may cause
plug connection to heat, damage plug or
outlet and cause a fire. If outlet is loose or worn,
discontinue using heater until the outlet can be
replaced.
CAUTION! High Temperature. Keep electrical
cords, drapes and furnishings away from
heater. Do not allow curtains or other furnishing
to contact heater. Maintain at least 6"
clearance around the heater at all times.
To reduce the risk of fire, do not store or use
gasoline or other flammable substances near
heater.
PAGE 2 OF 9
ASSEMBLY
Support Legs
OPERATION
Do not operate heater without support legs
attached as shown in Figure 1.
Do not allow heater to operate in any position
except shown in operating instructions.
Do not use heater near water or in humid
environment.
Heater is to be used on the floor only. Do not
use on a shelf, table or any location except the
floor.
NOTE: Heater is provided with a pilot light
ON/OFF switch and a temperature control
thermostat.
NOTE: Heater has automatic-resetting thermal
safety switch that will disconnect power to
the heating element should the heater be
placed into an abnormal condition (such as a
blockage) to prevent a fire. When the heater
cools, the safety switch will reset allowing the
heater to return to normal operation.
1. Plug heater power supply cord into 120 volt outlet.
2. Push ON/OFF switch to ON position.
NOTE: ON/OFF switch will illuminate when in the
ON position.
3. Rotate thermostat knob in a clockwise direction until
it stops.
Figure 1
Thermostat
Knob
0521 IH-6521