Installation And Operation; Installation - Bartscher CI20 Manual De Instrucciones

5. Installation and operation

5.1 Installation

Positioning

Unpack the device and remove all package materials according to the valid
environment protection regulations.
CAUTION!
Never remove the rating plate or any warning signs from the device.

Place the device on top of an even, stable, dry, and water-resistant surface which
supports the weight of the device and is not heat sensitive.

Never place the device in humid or wet environment.

Never place the device on the flammable surfaces.

Never place the device at the edge of the table, it could tip or fall down.

The installation surface must be easily accessible and sufficiently large. In order to
enable comfortable operation e of the device and ensure good air circulation, a
minimum distance of 20 cm to all sides must be kept.

Install the appliance device in such manner that the plug is accessible, so that the
appliance can be quickly disconnected from the power network if necessary.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
Connect the device only to properly installed single
socket with protective terminal.

The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
- 34 -