Bartscher CI20 Manual De Instrucciones página 41

WARNING! Hazards of burns!
Remove carefully the toast slices (bagels) from the toaster
because the metal parts of the appliance and the bread can
be very hot.
6. Disconnect the device from the socket (pull the power plug!), If it is no longer used.
Reheating of the already toasted bread
1. Perform the steps 1 - 4 of the section „Toasting".
2. Press the button „Reheating" . The toasting process begins and the control lamps
of the button „Cancel"
3. As soon as the toasting process is finished, the operating lever will jump upward and
the control lamps of the button „Cancel"
The toast slices can be taken.
Remove carefully the toast slices from the toaster. Hazards of burns!
NOTE!
 In order to finish the toasting process prematurely, press the button „Cancel"
The operating lever jumps upward and the toast slices can be taken out.
4. Disconnect the device from the socket (pull the power plug!), if it is no longer used.
Bagel toasting
and „Reheating"
and „Reheating"
1. Cut the bagel with a sharp knife and Insert the
two halves in the toast slots with the cut side to
the middle.
2. Insert the power plug into a grounded single
socket.
3. Turn the browning regulator to the desired level
of browning in the range of 1 - 6.
4. Press the operating lever down until it clicks.
to light up.
cease to light up.
.
- 37 -