Boppy Adjust Comfyfit Manual De Instrucciones página 11

• Your balance may be adversely affected by your move-
ments or by those of your child; the risk of fallin down
increases as the child becomes more active;
• Take care when bending or leaning forward and/or sideways;
• Do not use more than one baby wrap at a time.
• Do not use if any parts are missing or damaged;
• Do not use when it shows signs of wear (for example,
fibre balls/piling).
Correct use
Incorrect use
LIST OF COMPONENTS
COMPONENTS (fig. A and fig. B)
A. Belt with clasp
B. Underarm adjusting strap
C. Elastic fastener
D. Buttons for head support
E. Foldable collar
F. Belt strap
G. Closing straps
H. Labels
I. Internal seat
J. Opening for parent's arm
K. Pocket with zipper
L. Knitted panels
TIPS FOR CLEANING AND MAINTENANCE
CLEANING
Please refer to the care label.
After each washing check that the fabric and seams are
not worn or damaged.
Machine wash at 30⁰
30° C
Do not bleach
Tumble dry
Do not iron
Do not dry clean
MAINTENANCE
Check the seams and product regularly to ensure that
they are not worn or damaged and that no part is missing.
If any part is worn or missing, do not use the product.
REAR-FACING POSITION
HOW TO WEAR THE PRODUCT AND PLACE YOUR
CHILD
Attention: always fit the product onto your shoulders be-
fore placing your child inside it.
1. Clasp the abdominal strap around your bellybutton by
closing the clasp A (fig. 1) and adjusting the tension.
2. Fit the product and correctly position the inner seat I
(fig.2).
3. Insert your arm through the provided opening J (fig.3).
4. Insert your child, placing them correctly on the seat and
bring them close to your chest.
WARNING: Hold your child safely while carrying out this
operation (fig. 4).
5. Wrap your child with the structure of the product and
insert your other arm through the provided opening J
(fig. 5).
6. Correctly position the straps on your shoulders, as
shown on the labels applied on the product.
7. Tighten the straps sufficiently to support your child,
cross them over your back (fig. 6) and pull them to the
front (fig. 7).
8. Tie according to the weight and size of your child.
• For newborns, a simple knot is enough; cross the bands
over your child's legs, pass around the wearer's waist
once or several times and fasten them on your back with
a double knot. (fig. 8)
• For children over 5 kg, use the leg pass, firstly crossing
over the child's legs and then under them. The straps can
then be secured with a double knot on the back.
9. Adjust the tension of the buckle under the shoulder line.
(fig. 15).
WARNING: Do not leave the belt fabric loose over the
shoulders, tighten properly.
WARNING: To tie the knot correctly, refer to the images
(fig. 10 -11-12-13-14).
WARNING: Do not tie the ends of the straps near the ab-
domen or lower limbs of your child to prevent squeezing.
The straps must not fall below the knees of the adult user.
Wrap them around your waist again if necessary.
WARNING: Tie the knot correctly. Make sure that it is
good and tight and does not come loose while being
used (fig.14).
FORWARD-FACING POSITION
From the moment your child is able to hold up their head
and keep their shoulders vertical, which is approximately
from the age of 6 months, you can transport your child in
the forward-facing position (fig.16). Be sure the integrated
head support is folded and facing down to ensure that
your baby's nose and mouth are free from obstructions. It
is suggested to limit the time your baby spends in this po-
sition, only when the baby is active and curious of looking
at the world. Listen to your baby's signals: in case of over-
stimulation or tiredness it is prefered to wear it front-fac-
ing. Never use while the baby is sleeping.
To fit your child, repeat the sequence of steps indicated
11