Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2609932606 07-07
REMOVING AND INSTALLING
SANDING BELTS
To prevent personal injury,
!
WARNING
always disconnect the plug
from the power source before removing or
installing the belt.
TO REMOVE BELT:
1. Place sander upside down and move belt
tension release lever in direction of arrow to
retract front pulley and release belt tension.
2. With the sander upside down and the open
side facing you, you can easily remove the belt.
TO INSTALL BELT:
1. While the sander is still upside down, with
the front pulley retracted and locked, insert the
new belt around both pulleys and over the
platen plate. If the sanding belt has "rotation
direction" markings, be sure the arrow on the
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your sander is equipped with a variable speed
trigger switch. The sander can be turned "ON"
or "OFF" by squeezing or releasing the trigger.
The speed can also be adjusted from,
miminum to maximum nameplate rated RPM
by the amount of pressure you apply on the
trigger. Apply more presssure to increase
speed and release pressure to decrease
speed.
"LOCK-ON"
BUTTON
VARIABLE
SPEED TRIGGER
SWITCH
The "Lock-ON" button, located near the trigger
allows continuous operation at maximum RPM
without holding the trigger.
TO LOCK TRIGGER ON:
depress button and release trigger.
TO UNLOCK THE TRIGGER: Squeeze trigger
and release it without depressing the "Lock-
ON" button.
7/10/07
8:15 AM
Assembly
Operating Instructions
VARIABLE
SPEED DIAL
Squeeze trigger,
Page 7
inside of belt is pointing in the direction of
rotation as indicated on housing.
2. Then push lever back to its original position
to return tension to the belt.
FRONT
PULLEY
DIRECTION
OF ROTATION
BELT TENSION
RELEASE LEVER
If the "Lock-ON" button
!
WARNING
is
depressed, the trigger cannot be released.
VARIABLE SPEED DIAL
This feature enables you to preset the trigger at
desired speeds by rotating the dial on the
trigger. Regardless of the pressure applied on
trigger, the tool will not operate any faster than
maximum preset speed. You can change the
preset maximum speed simply by rotating the
adjusting dial to a higher or lower speed
setting. As a guideline, the following speed
selections apply:
Dial setting
Material/Application
A thru C
Delicate surfaces, veneers,
and with sanding frame for
light surface finishing
B thru D
Plastics or other surfaces
where belt loading or heat
buildup is a problem
C thru E
Solid wood, fast stock
removal, paint removal
E
General service, metal
sanding, chipboard, coarse
sanding on rough surfaces
-7-
REAR
PULLEY
PLATEN
PLATE
continuously
being
Publicidad
Tabla de contenido
