AgfaPhoto AC8131D Manual Del Usuario página 8

ac-8131d_easyinstall-03_en-253259657-a .book Seite 2 Donnerstag, 20. August 2009 1:21 13
2 Alarm Clock
Switch On
1 Insert the small plug of the power supply into the sock-
EN
et on the rear side of your device. Insert the power sup-
ply unit into the socket.
2 Press and hold the B POWER button on the reverse
until the device switches on.
Automatic switch on of the screensaver
If no button is pressed in a function for a cer-
tain period of time, the screensaver automati-
cally switches on. Use SNOOZE to return to
the function from which the screensaver was
turned on.
Setting the Time
1 Press õ to call up the settings menu
2 Using Å/Æ select the Clock-symbol and confirm using
OK to set the time.
3 Press OK to highlight the hours.
4 Using Å/Æ to select hour or minutes.
5 Modify the time using Ç/Î.
6 Confirm with OK.
Setting the Alarm Time
1 Press ó to call up the settings menu for the wake-up
time
2 Using Ç select setting 'On' or 'Off'
3 Select 'On' using Å/Æ to switch on the alarm.
4 Select further settings (Hour/minutes, Alarm tone,
alarm photo mode) using Ç/Î.
5 Select hour/minutes or the required settings using Å/
Æ.
6 Change the alarm time or the settings using Ç/Î.
7 Confirm with OK.
8 When the alarm is ringing choose from the following
functions:
Press SNOOZE long or press another button: Alarm
is switched off.
Press SNOOZE short: The wake-up signal is switched
off, however it sounds every 5 minutes for two more
times if no other button is pressed in the meantime
(snooze function).
2
Listen to the Radio
1 Press ô to switch on the radio.
2 Select the stored channels using Ç/Î or start the auto-
matic channel search by pressing and holding Å/Æ.
3 Press OK to store the searched channel.
The frequency range is from 87.0 MHz to 108.0 MHz,
in intervals of 100 kHz. You can store up to 12 stations.
4 Use controller †/‡ to adjust the volume.
5 Press ô to switch on the radio.
Enjoy Your Images
1 Insert a memory card into the slot on the side of the de-
vice. Your photo frame supports the following memory
cards: SD/SDHC/MS/MMC.
2 Press ö to call up the photo menu
3 Use Ç/Î, Å/Æ to select an image and confirm using
OK in order to view the image.
4 Press OK to start the slide show.
5 Press OK to stop the slide show and to continue.
6 End the slide show using ö.
Setting the Display Brightness
You can choose from two settings for the display bright-
ness.
1 Press õ to call up the settings menu
2 Use Ç/Î to select the symbol for the display brightness
(Incadescent lamp)
3 Use Ç/Î to select the 'Sun-symbol' for the day or the
'Moon-symbol' for the night.
4 Change the brightness using Å/Æ.
You can switch between both of these settings
by pressing and holding the SNOOZE but-
ton.
Setting the Screensaver
If no key is activated for a certain period of time, the
screensaver automatically switches on. You can adjust what
information is to be displayed as the screensaver.
1 Press õ to call up the settings menu
2 Using Ç/Î to select the rightmost symbol in the lower
row (view of the set)
3 Use Ç/Î to select from the following three settings:
Slide show, time or Demonstration Mode (Slide show
with factory stored images).
AgfaPhoto AC8131D