Yakima DoubleDown 2 Manual Del Usuario página 2

Install tongue.
push the tongue into the hitch
plate, aligning the holes.
If your vehIcle's hItch Is 1 1/4":
remove the 2" hItch aDapter,
anD the plastIc sleeve.
for 2" hItches: proceeD
to next step.
Remove the bolt from
the adapter using
the hex wrench.
Install large bolt, lock-washer, anD washer.
install bolt, lock-washer, and washer
•
from right side of receiver.
NOTE: Flat washer may
be discarded on some
1-1/4" receivers if there
are clearance issues
with receiver.
Washer must be
used on 2" receivers!
15
1033437H-2/
• Install hex bolt and a flat washer.
• Add a second washer, attach a nut.
Remove the
adapter, and
sleeve from the IF SPARE TIRE CAUSES
INTERFERENCE, DO NOT
tongue.
USE THIS PRODUCT!
TIgHTEN with adjustable wrench.
•
Insert tongue Into
vehIcle's hItch.
Align the holes in the receiver
to the holes in the tongue.
Install safety pin.
•