Troubleshooting; Technical Data; Limited Warranty - GreenWorks 20192 Manual Del Operador

EN
12

TROUBLESHOOTING

Problem
The machine does
not start.
The bar and chain
gets hot and
smokes.
The bar and chain
gets too hot and
can not cut.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3
seconds.
Possible cause Solution
The poles are not Assemble the
assembled cor- poles according to
rectly. the instructions.
1. Push and hold
the lock-out
button
2. While you
The lock-out but- hold the lock-
ton and trigger are out button,
not depressed at pull the trig-
the same time. ger.
3. Release the
lock-out but-
ton to start the
machine.
Oil tank is empty. Fill the oil tank.
1. Remove from
power supply.
The discharge
2. Remove dirt
port is blocked.
from the dis-
charge port.
1. Clean the oil
tank.
Inlet opening of
inner oil tank is
2. Fill with clean
blocked.
bar and chain
lubricant.
The sprocket is 1. Clean the
stuck and clogged sprocket.
with debris.
2. Fill with clean
bar and chain
lubricant.
The chain tension Refer to Adjust
is too tight or too the Chain Tension
loose. in the manual.
Sharpen or re-
The chain is dull
place the chain.
Take out the chain
The chain is put
and turn it in the
on backwards.
right direction.
1. Release the
When you use the
trigger.
machine under
2. Start the ma-
load, it stops.
chine again.
Lubricate the
The chain is not
chain to decrease
lubricated.
the friction.
English
13

TECHNICAL DATA

Motor
No load speed
Guide bar length
Chain pitch
Chain gauge
Drive links
Chain oil capacity
Weight
Chain
Guide bar
14

LIMITED WARRANTY

Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of three (3)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
2. The unit, if it has not been operated and/or maintained in
accordance with the owner's manual; or
3. Normal wear, except as noted below;
4. Routine maintenance items such as lubricants, blade
sharpening;
5. Normal deterioration of the exterior finish due to use or
exposure.
HELPLINE:
Warranty service is available by calling our toll-free helpline,
at 1-888-909-6757.
12
120 V AC, 60 Hz, 6.5 Amp
7000 RPM
203 mm
3/8" LP (9.5 mm)
.043" (1.1 mm)
33
80 ml
4 kg
91PJ033X/CL15033X
080NDEA318/
M1500833-1318TL
3
YEAR
ANS
AÑOS
LIMITED WARRANTY
GARANTIE LIMITÉE
GARANTÍA
LIMITADA