Publicidad
MANUAL
EN
FLINQ LUXXTREE FLAGPOLE LIGHT CHAIN
Safety instruction:
Read the user instructions carefully before use.
Save these instructions for future reference.
See packaging and label on the product.
Warning:
• The product must be free of all packaging before
use!
• If the product is broken or there are other
irregularities – do not use it.
• This product is for indoor and outdoor use (IP44).
• Bulbs and cable cannot be removed or replaced.
• Do not in any way try to alter the product.
Use:
There are 2 buttons on the control box.
Left button: Timer
Right button: Mode
Left button "Timer" can activate the dimmer
function and the timer function:
Dimmer function:
Press timer button (short press) to use dimmer
function (4 levels).
These functions can also be activated on the remote
control.
Timer function:
To activate the timer function press timer button
for 3 seconds, a green light will turn on. The timer
function 6h on / 18h is activated.
Press the timer button again for 3 seconds, a red
light will turn on. Timer function 8h on / 16h is
activated.
To turn off the timer function, press the same timer
button again for 3 seconds. The light will turn off to
indicate that the timer function is now off.
The timer settings can also be used on the remote
control.
MODE Button:
10 Functions - Press right button to switch between
the functions.
1. COMBINATION
2. IN WAVES
3. SEQUENTIAL
4. SLO-GLO
5. CHASING/FLASH
6. SLOW FADE
7. TWINKLE/FLASH
8. STEADY A
9. STEADY B
10. STEADY C
Explanation of safety classes:
Light chain is Class III, with Class II adapter.
= Safety class III. The voltage is so low, that a
person under normal circumstances can get
in touch with this without risk of shock.
= Safety class II. User protection from
electric shock is achieved through two levels
of insulation (either double or reinforced)
2
Publicidad
