Segway i2 Fender Manual De Instrucciones página 2

Table of Contents
Table des matières • Sommario • Inhaltsverzeichnis •
Contenidos • 目次 • 目录
English
Français
Italiano
Deutsch
Español
日本語
中文
3
6
9
12
15
18
21
2
i2 Fender • i2 Tire & Wheel
20945-00001 Fender • 20942-00001 Tire & Wheel
Tools required
13mm socket wrench
T20 six-lobe wrench
Installation instructions for all Segway
1. Make sure the Segway PT is unplugged and powered off.
2. Tip the Segway PT onto its side so the Fender you want to remove is facing up
and the other Wheel rests against a clean, smooth surface. See Figure 1.
3. Remove the Wheel Cap by pressing down on the outside edge and lifting the
opposite outside edge with your fi ngers or a plastic wedge.
4. Hold the Wheel to keep it from rotating and remove the (3) Wheel Nuts with a
13mm socket wrench. You will need the (3) Wheel nuts to re-install the wheel.
WARNING!
Before performing any maintenance or installing any part or accessory:
Shutdown Unplug
Follow all instructions carefully to avoid
the Segway PT. the Segway PT. serious injury, death and/or damage to the
Segway PT, rendering it unsafe to use.
The Tire & Wheel Assembly must be properly installed and secured. Failure to
properly install the Tire & Wheel Assembly or to adhere to torque specifi cations
when tightening Wheel Nuts could result in machine malfunction and could
cause personal injury or damage to your Segway PT.
Included with kit
(1) i2 Fender
(4) Fasteners, 11mm long
OR
(1) Tire & Wheel
(3) Wheel Nuts
(1) Wheel Cap
i2 models
®
3