Minimum Distance Placement Of The Device & Notes; Instructions: Using The Device - V-TAC VT-2000WRD Manual De Instrucciones

MINIMUM DISTANCE PLACEMENT OF THE DEVICE
Glass convector heater must be placed on the desired location carefully and ensure the distance between the
wall and objects is minimum 50CM to 100CM
NOTES
Stand BY Mode: When the device is restarted after its cool down period the device will start in Standby
mode (25°C-27°C).
Cool Down Period - After using the heater please power off the device and allow minimum 30 minutes for
the device to cool down. Please note the device cool down period will be subjected to the usage period, the
room size and other factors. Due to which please allow minimum 30 minutes if required please allow more
time until the device has been completely cooled down.

INSTRUCTIONS: USING THE DEVICE

1. Once the device has been positioned successfully maintaining the minimum distance placement of the device
(Min 50-100CMs).
2. Ensure power is switched OFF and connect the EU plug into the power outlet and switch the power ON.
3. On the side of the device, set the switch (Point E) to ON position (Refer Figure 1). The device will start with a
beep sound and the LCD display will light up.
11
ENGLISH