Installation Instructions (Foot Assembly) - V-TAC VT-2000WRD Manual De Instrucciones

APPLICATIONS
1. Note: This product is only designed
for use inside well insulated rooms or
for occasional use.
2. The device must only be used in
closed rooms.

INSTALLATION INSTRUCTIONS (FOOT ASSEMBLY)

Please ensure you have all the accessories (included) foot and screws
to assemble on the device
1. Please make sure the device is not connected to power.
2. Carefully place the device (glass convector heater) down (as
shown below) on a protected surface. Ensure the tempered glass
surface is facing downwards.
3. Using the ST4*12*3 screws install the feet on the device (glass
convector heater). Ensure the feet is properly fixed on the device.
4. Carefully lift the device up to its position. You can now move and
place the device in the desired location you choose.
NOTE: Using the lock feature on the brakes you can park the device
on the location to ensure its stability.
NOTES
1. Carefully unpack the box and remove the device and accessories.
Place the device (glass convector heater) on a protected surface.
Ensure the feet is properly fixed on the device.
2. Please check if all the articles are included and there is no
damage seen.
8
ENGLISH
°C
_
+