Configuring Audio Ports - Toshiba PA3838U-1PRP Manual De Instrucciones

18

Configuring audio ports

2 Set the computer lock switch on the port replicator to the
locked position.
3 Insert the lock end of the security cable into the port
replicator's security lock slot.
4 Turn the key or set the combination on the end of the security
cable.
(Sample Illustration) Connecting a security cable to the port
replicator
Configuring audio ports
You can playback or record audio through the audio ports on either
the port replicator or the docked computer. However, you cannot
use the audio ports on the docked computer and on the port
replicator at the same time.
By default, the audio ports on the port replicator are automatically
enabled each time you dock the computer. When you undock the
computer, the audio ports on the computer are automatically
re-enabled.
To change the default settings, you will need to manually adjust the
audio settings in Windows
If your media player is running when you undock or dock, you must
close the application and wait approximately 10-15 seconds for the
new settings to take effect before restarting the application.
Audio devices connected to the port replicator via the 3.5 mm audio
jacks will appear as USB Multimedia Audio Devices in Windows
although they are not connected to a USB port. This does not affect
the operation of the devices.
Security lock slot
®
as described in this section.
®