Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Before completely removing bumper fascia
for DIESEL ENGINES ONLY disconnect engine
heater connector. Connector wire is held to the bumper
by a push pin fastner located near the middle bumper
opening.
8.
Pull bumper fascia out slightly to access and remove the
(5) lower cover push pins attached to the bottom of
the bumper. Retain for reinstallation.
NOTE: The push pins must be removed
from inside.
9.
Remove bumper fascia and with care set aside.
10.
Prior to removing the bumper brackets mark side
rails as shown to aid in reinstallation alignment of
bumper fascia.
NOTE: Repeat for drivers side.
11.
Remove (2) 18mm nuts for both right and left sides.
(4) total nuts retain for reinstallation.
NOTE: Repeat for drivers side.
03/01/2010
3
K6860880
Publicidad
