Product Features - HoMedics PRO MASSAGER Manual Del Usuario

PRODUCT FEATURES:

The HoMedics Pro Massager is a cordless reciprocating massage device that penetrates deep into your muscle layers to relieve
aching and stiff muscles, helping you feel relaxed, recharged, perfect for after sport or physical activity.
Barrel head Cool head
INSTRUCTIONS FOR USE:
1. Screw the desired massage head into the socket on the front of the
product.
2. Turn the speed selector ring on the base of the product clockwise to your
required speed setting, the speed indicator LED(s) on the back of the
product will illuminate corresponding to the speed chosen.
3. Gently move the massage head over the part of the body you wish to
massage at first and then apply more pressure as desired. If you have
not used this type of product before it is recommended that you
start on level I speed and press gently as the product provides an
intense massage.
4. You should massage each area for approx. 30 seconds to 1 minute,
please refer to our quick start guide included with the product for more
detailed information on how long to use the product for on each body
part.
5. If you wish to increase or decrease the speed of the massager, turn the
speed selector ring accordingly.
6. Once you are finished with your massage, turn the speed selector ring to
the 0 position to turn the massager off.
Using the heated head
1. Screw the heated head into the massager.
2. Turn the speed selector ring to the desired speed.
3. Start massaging, the head will take 2 mins to get to full temperature,
whilst the head is heating the LED's will flash. Once the LED's stay lit, the
head is at full temperature.
4. Use the massager as described in point 4 of the 'Using your device'
section.
5. Once you are finished with your massage, turn the speed selector ring to
the off position and allow the head to cool before putting back into the
case.
Speed Selector
Arrow head Heated head Cellulite head
Ball head
I I
2 2
Using the Cool head
1. Place the cool head in a freezer for at least 4 hours
2. Screw the cool head into the massager.
3. Turn the speed selector ring to the desired speed.
4. Use the massager as described in point 4 of the 'Using your device'
section
5. Once you are finished with your massage, turn the speed selector ring
to the off position and remove the cool head, placing it back into the
freezer if desired.
6. Do not store the cool head in the case if it is damp due to condensation
from recent use.
Charging your device
1. To charge the product, plug the adaptor into a 220-240V mains outlet
and connect the cable to the charging socket on the bottom of the
handle
2. Once the charging cable is connected the charge indicator LED's should
start to flash, this will indicate the product is charging.
3. The product will require 2.5 hours of charging for up to 3.5 hours of use.
(Pending testing).
4. Once the product is fully charged the indicator lights will remain fully
illuminated.
5. Disconnect the product from the mains power supply once it is fully
charged.
Cleaning your device
Make sure the device is unplugged from the mains supply and allow to cool
before cleaning. Clean only with a soft, slightly damp sponge.
• Never allow water or any other liquids to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint
thinner etc to clean.
GB GB
Speed Indicator LED
Power Adaptor Power Adaptor
Charging Socket
Charge Indicator LED