Notes On Safety; Symbols Used In The Instructions; Symbols Used On The Saw - Parkside PKSA 40-Li A1 Manual Del Usuario

Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting
the working hours. All parts of the
operating cycle are to be taken into
account in this (for example times in
which the electric tool is turned off
and those in which even though it is
turned on, it is not running under a
load).

Notes on safety

This section deals with the basic safety reg-
ulations while working with the chainsaw.
A chainsaw is a dangerous device,
which can cause serious or even
fatal injuries with incorrect or care-
less use. Thus, for your own safety
and the safety of others, you should
always take note of the instructions
on safety and, in case of difficulties,
consult a specialist for advice.
Symbols used in the
instructions
Hazard symbols with in-
formation on prevention of
personal injury and property
damage.
Precaution symbol (explanation of
precaution instead of exclamation
mark) with information on preven-
tion of harm / damage.
Notice symbol with information on
how to handle the device properly.
Wear protective gloves in order to
avoid cutting yourself!

Symbols used on the saw

A chainsaw is a dangerous device,
which can cause serious or even
fatal injuries with incorrect or care-
less use. Thus, for your own safety
and the safety of others, you should
always take note of the instructions
on safety and, in case of difficulties,
consult a specialist for advice.
Read and take note of the operating
manual belonging to the machine
Wear personal protective equip-
ment. Basically, wear protective
goggles or, even better, face protec-
tion, safety helmet, cut-protection
working clothes and ear protection
Use protective clothing
Wear cut-protection gloves
GB IE
35