Intended Use - Worx WX283 Manual Original

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
Indoor use only
Do not expose to rain or water
10
Do not burn
Do not dispose of batteries. Return
exhausted batteries to your local
collection or recycling point
Li
Always charge the battery pack
between temperatures 0
3 in1 drill/driver/impact driver
OPERATING INSTRUCTIONS

INTENDED USE

The machine is intended for driving in and
loosening screws as well as for drilling in
wood, metal and plastic.
BEFORE PUTTING INTO OPERATION
A) BATTERY CHARGING
The battery charger supplied is matched to the
Li-Ion battery installed in the machine. Do not
use another battery charger.
The Li-Ion battery is protected against deep
discharging. When the battery is empty,
the machine is switched off by means of a
protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
When the battery is charged for the first time
and after prolonged storage, the battery
will only accept approximately 60% charge.
However, after several charge and discharge
cycles the battery will accept a 100% charge.
B) TO REMOVE OR INSTALL BATTERY
PACK (See Fig. A)
Depress the battery pack release button to
release and slide the battery pack out from
your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be
sufficient.
OPERATION
1. INSTALLING OR REMOVING A
DRIVER BIT, DRILL BIT OR DETACHABLE
KEYLESS CHUCK (See Fig. B)
C to 30 C
o o
To install the desired bit or the detachable
keyless chuck, pull the collet locking sleeve (7)
forward and insert the desired bit or hex shank
of the detachable keyless chuck into the sleeve
as far as it will go. Then release the collet
locking sleeve to secure the bit or the chuck.
To remove the bit or the chuck, pull the collet
locking sleeve (7) forward and take the tool
out firmly.
NOTE: Before using the tool, read the
instruction book carefully.
EN