Technical Data; Noise Information; Vibration Information - Worx WX283 Manual Original

TECHNICAL DATA

Type WX283 WX283.3 WX283.9 (280~289-designation of machinery, representative
of Cordless Impact Driver)
Voltage
Screwdriver mode
No load speed Drill mode (Lo-Hi)
Impact driver mode
Impact rate
Impact driver mode
Max torque
Drill mode
Torque setting
Wood
Drilling capacity
Steel
Chuck type
Machine weight

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection when sound pressure is over

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 60745:
Typical weighted vibration
WARNING: The vibration emission value during actual use of the power tool can differ
from the declared value depending on the ways in which the tool is used dependant on the
following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
Always use the correct accessories for the tool and ensure they are sharp and in good condition.
And the tool is being used as intended by its design and these instructions.
This tool may cause hand-arm vibration syndrome if it is not managed correctly.
3 in1 drill/driver/impact driver
Vibration emission value a
Uncertainty K = 1.5m/s²
12V
0-600/min
0-600/ 0-2200/min
0-2200/min
0-3000 /min
100 N.m
15 N.m
20mm
8mm
6.35 mm (1/4") hex
1.2kg
L :80.9dB(A)
pA
L :91.9dB(A)
wA
3.0dB(A)
80dB(A)
= 3.74m/s
2
h
EN
22
7