Cooling Down - Raider RDI-HG24 Manual Del Usuario

- Secure the cable to prevent pulling the tool off the workbench.
- Carefully switch the tool on.
Make sure that the nozzle always points away from you and any bystanders.
Make sure not to drop anything into the nozzle.

5.9. Cooling down

The nozzle and accessory become very hot during use. Let them cool down before
attempting to move or store the tool.
- To reduce the cooling time, switch the tool to position I which is at the lowest air
temperature and adjust the air flow to Max. and let it run for a few minutes.
- Switch the tool off and let it cool down for at least 30 minutes before storage.
6. Care and maintenance.
Always unplug the power cord before plugging in any of the accessories. Always keep the
ventilation holes open and clean.
Regularly clean the case with a soft cloth, if necessary moistened with soapy water. Your
power tool does not require additional lubrication. Never use solvents such as petrol, alcohol,
ammonia, etc. These solvents can damage the plastic parts.
7. Environmental protection.
The machine, accessories and packaging should be sorted for environmental-friendly
recycling.
Do not dispose of power tools into household waste!
According the European Directive 2012/19/EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power tools that are no longer usable must be
collected separately and disposed of in an environmentally correct manner.
11