Getting Started - Denver CRL-300 Manual Del Usuario

•

GETTING STARTED

1. AC / DC Adaptor (Included)
The 6V adapter powers the unit. Plug adapter into socket, making sure the adapter is not
obstructed and is easily accessible to the unit.
CAUTION! To take off the wall power connector you have to remove always from the
adapter and never from the cable. The main unit and adapter should not be exposed to
wet conditions. No objects filled with liquid, such as vases, should be placed on the main
unit or adapter.
2. Battery installation
The CR2032, 3V battery can act as a backup power supply for the main unit.
(1) Remove the battery compartment at the bottom of the unit.
(2) Insert the batteries, matching the polarities.
(3) Press RESET after each battery change
CAUTION! Don't let the battery from the reach of children.
Don't try to activate the battery by heat, recharge or any other way.
Don't drop the battery to the fire, disassemble or try to do a short circuit.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
The battery shall not be exposed to excessive heat such as sunshine, fire or the likeness.
•
QUICK USER GUIDE
1. Time & Date
When you power on the Clock Radio, it begins with:
YEAR: 2009 / DATE: 1 / MONTH: 1 / WEEK: Thursday. And the time on 12:00AM (00:00).
To adjust the time and date is necessary:
• Press the SET button; you can see the year place blinks, in that moment you can use the UP / SNOOZE or DOWN /
12 / 24 buttons to select the correct year.
• Press the SET button again; you can see the month place blinks, in that moment you can use the UP / SNOOZE or
DOWN / 12 / 24 buttons to select the correct month.
• Press the SET button again; you can see the day place blinks, in that moment you can use the UP / SNOOZE or
DOWN / 12 / 24 buttons to select the correct day.
• Press the SET button again; you can see the hour place blinks, in that moment you can use the UP / SNOOZE or
DOWN / 12 / 24 buttons to select the correct hour.
• Press the SET button again; you can see the minutes place blinks, in that moment you can use the UP / SNOOZE or
DOWN / 12 / 24 buttons to select the correct minute.
• Finally press the SET button to confirm and finish the setting.
2. Alarm
2.1. Set the alarm time
To set the alarm you need:
• Press the ALARM button, by standard the time is 12:00 AM, to set the alarm time you have to press the SET button
and use the UP / SNOOZE or DOWN / 12 / 24 buttons to adjust to hour that you wish. Press the SET button again to
adjust the minutes.
ENG-3