Troubleshooting Guide - Denver BTS-400 Manual De Instrucciones

jack of an audio device and plug the other end into the Aux -in jack located on back of
the main unit .
2. Press the
control to turn on the unit.
3. Press MODE Button until the power indicator turns to Green to enter
the AUX-IN mode.
4. Start the playback of the audio device connected.
5. Press "Vol +" / "Vol – " key on remote control or press and hold the">"/ "<"button
on the main unit to raise/lower the volume level. When finished, press and hold the
button on the main unit or press & hold the
the main unit. Remember to turn off your audio device, too.

TROUBLESHOOTING GUIDE

Should you experience difficulties in the use of this player, please refer to the
following chart.
Fault
Unit cannot be
operated.
No audio signal
via the Bluetooth
connection
Speaker cannot
be connected
button on the main unit or press & hold the
Cause
Unit crashes and
"hangs"
Speaker is not paired
to the audio source.
Volume too low
Pairing does not
work
Audio source
switched off
Bluetooth is switched
off at the
source.
Bluetooth version is
not supported.
key on remote control to turn off
Disconnect from the mains for around 5
seconds. Then switch the unit on again.
Check whether a connection exists. If
necessary, pair the speaker again to the
audio source.
Increase the volume on the speaker
Increase the volume on the the audio
source.
Check whether the audio source
supports the A2DP protocol
is
Switch on the audio source
Switch on the Bluetooth function in the
audio
audio source.
Use a different playback unit.
7
key on remote
Solution