Rotel RKF-100 Manual De Instrucciones página 4

RKF-100 Cooling Fan Kit
The RKF-100 is a versatile system that enables you to confi gure the direction of the airfl ow in many different
Be sure to disconnect the power supply before removing the top cover.
Front
Exhaust
Rear
Exhaust
Top Exhaust
(Front Entry)
Top Exhaust
(Bottom Entry)
How To Confi gure The RKF-100 For
Different 'Air-Direction' Flow
ways according to the specifi c needs of your installation.
1 LOOSEN SCREWS ON BOTH SIDES AND LOWER INSIDE
FAN ASSEMBLY TO BOTTOM POSITION AND RETIGHTEN
2
REMOVE TOP COVER AND PLACE FOAM BLOCK
BEHIND FRONT PANEL TO BLOCK AIR FLOW
1
LOOSEN SCREWS ON BOTH SIDES AND LOWER INSIDE
FAN ASSEMBLY TO BOTTOM POSITION AND RETIGHTEN
1
LOOSEN SCREWS ON BOTH SIDES AND RAISE INSIDE
FAN ASSEMBLY TO TOP POSITION AND RETIGHTEN
2
REMOVE TOP COVER AND PLACE FOAM BLOCK
BEHIND FRONT PANEL TO BLOCK AIR FLOW
1
LOOSEN SCREWS ON BOTH SIDES AND RAISE INSIDE
FAN ASSEMBLY TO TOP POSITION AND RETIGHTEN
4
2
SCREW PLASTIC
COVER OVER TOP
COVER VENTS
SQUEEZE FOAM
3
CYLINDERS AND
INSERT IN BOTH
REAR HOLES TO
BLOCK AIR
3 REPLACE TOP COVER
AND SCREW PLASTIC
COVER OVER AIR VENTS
SCREW AIR TUBING IN REAR PANEL
4
HOLE FOR TWO TURNS TO SECURE.
USE TWO TUBES FOR MAXIMUM
VENTING OR BLOCK AIR IN SECOND
HOLE WITH FOAM CYLINDER AS
SHOWN ABOVE.
SQUEEZE FOAM
3
CYLINDERS AND
INSERT IN BOTH
REAR HOLES TO
BLOCK AIR
2
SCREW PLASTIC COVER
OVER BOTTOM COVER VENTS
SQUEEZE FOAM
3
CYLINDERS AND
INSERT IN BOTH
REAR HOLES TO
BLOCK AIR