Fitting The Battery - Flow Amsterdam Nidal Guia De Inicio Rapido

Fitting the smoke detector
Ceiling
Best here
Bedroom Bathroom
Kitchen
Bedroom
Landing
Livingroom
Smoke alarm for minimum protec�on
Smoke alarm for op�mal protec�on
Heat alarm
Early detection of re is done most e ectively by placing smoke
alarms in all rooms and areas of the house.

Fitting the battery

Connect the battery
Fit the battery
FLOW SMOKE DETECTOR
FLOW SMOKE DETECTOR
Photoelectric Smoke Detector
Photoelectric Smoke Detector
Model: 1015027
Use only the following batteries:
Battery 9V LR61 or 6F22 Model: 1015027 Use only the following batteries:
Production date: xx/xx/xxxx
Production date: xx/xx/xxxx Battery 9V LR61 or 6F22
Replace smoke detector before: xx/xx/xxxx Test the alarm for correct operation using the
test facility, whenever the battery is replaced. Replace smoke detector before: xx/xx/xxxx Test the alarm for correct operation using the
Manufactured in China by:
test facility, whenever the battery is replaced.
Flow Products International b.v. Manufactured in China by:
XX Flow Products International b.v.
Madridstraat 8 XXX-CPD-XXXXXXXX
Madridstraat 8
1175RK Lijnden EN 14604:2005
1175RK Lijnden
the Netherlands XXXX
the Netherlands
Warning: the battery cover will only close once a battery has been tted.
Removing the battery causes the smoke alarm to stop working.
Replacing battery
The smoke alarm works with a 9V DC block battery. When dealt with under normal
circumstances, the average life time of this battery is at least one year. in case of an (almost)
empty battery, the smoke alarm alerts you by transmitting an audible "beep" and a ashing LED
lamp. This happens simultaneously every 30 to 40 seconds for a minimum of 7 days.
Replace battery when this signal occures.
30 cm
Minimum
Never
install here
Wall
Bedroom Bedroom
Hall
Kitch- Living
Hall
en Room
Basement
XX
XXX-CPD-XXXXXXXX
EN 14604:2005
XXXX
Installation of smoke detector
Screw mounting plate
Fit the smoke detector on the
into wall or ceiling
wall or ceiling with tape.
Attention: this intelligent smoke detector needs around 6 seconds to perform a test and an automatic calibra-
tion. This process starts once smoke detector is connected to its battery. A single ash of its red light, states that
the smoke detector has gone into operating mode.
Functions:
Operating mode: the red LED indication ashes every 50 seconds, meaning the device is opperating correctly.
Alarm: the red LED indication light ashes continuously along side the audible alarm that is being transmitted:
smoke is detected.
Testing: you can test the smoke detector when it's in its operating mode, press the button until the LED indication
ashes and the sound alarm is being transmitted. Release the button to stop testing.
Error: errors are indicated by the red LED indication light ashing 5 times simultaneously to 5 audible beeps
sounding every 20-30 seconds.
Low voltage: the red LED indication light ashes once, simultaneously to1 beep sounding every 30-40 seconds.
Lifetime: the red LED indication light ashes 3 times, simultaneously to 3 audible beeps sounding every 50-60
secon
ds.
Usage
Press the test button on the smoke alarm until the alarm signal sounds. Test the smoke
alarm once a week, after a period of absence, after cleaning the smoke alarm and test it
everytime its battery is replaced. The smoke alarm must be regularly vacuumed to remove
any dust particles and ensure optimal working condition.
Removal
Handle this battery as chemical waste. Do not throw away the smoke alarm as normal
household refuse, but hand it in to be recycled. Question your municipal environment
service to hand in possibilities for recycling.
What should you do in case of re
- Leave the house immediately according to its ight route. Every second counts, don't
waste time getting dressed and/or collecting valuables.
- Stay close to the ground in case of heavy smoke, breathe softly through a (wet) cloth.
- Once outside, call the re department. Do not make this phonecall from inside the house.
Ask neighbors for help if necessary.
- Only enter the house once it is declared save by the re department.
put cover into place by
Turn back up to secure smoke detector
turning it 30 degrees turned