Using The Remote Control - Toshiba XF355 Serie Manual De Instrucciones

Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
GREEN LED – Active standby (digital only)
GREEN LED – Timer (analogue only)
Switching on
If the RED LED is unlit check that the mains plug is
connected to the power supply. If the picture does not
1
appear press on the remote control, it may take a few
moments.
To put the television into Standby press
control, the GREEN active standby LED will appear (see
'Software Upgrade' section) next to the RED for a few
moments then disappear. To view the television press
again. The picture may take a few seconds to appear.

Using the remote control

Press the MENU button on the remote control to see the
menus.
In digital mode the menu bar at the top of the screens will
show three different topics shown in symbols. As each
symbol is selected by pressing the
remote control, its respective options will appear below.
In analogue mode the menu appears as a list of six topics.
As each symbol is selected by pressing the
on the remote control, its respective options will appear
below.
BLUE LED
1
on the remote
1
C c
or button on the
C c
or button
11
RED LED – Standby
GREEN LED – Power on
To use the options press the
control to move up and down through them and OK,
c
to select the required choice. Follow the on-screen
instructions. The functions of each menu are described in
detail throughout the manual.
Using the controls and connections
To alter the volume press –
To alter the programme position press
I i u
Press MENU and , , or
picture options.
Press MENU twice to finish.
When connecting sound equipment to EXT3, connect the
audio output of the equipment to the phono sockets on the
television.
o
To select the Input, press
as described on page 36. The television will automatically
sense the type of signal.
Please always refer to the owner's manual of the equipment
to be connected for full details.
Please note: Inserting the headphone plug will mute the
sound from all speakers.
Standby
HDMI3
INPUT
INPUT 3
(EXT3)
B b
and button on the remote
C
2
+.
b p B
.
U
to control the sound and
until the display shows EXT3
or