Toshiba XF355 Serie Manual De Instrucciones página 45

Questions and
Q
Why are there no analogue text sub-pages?
A
There are none broadcast or they have not yet
loaded. Press the l button to access.
(See text section).
Q
Why are the four coloured text numbers visible
but no text?
A
Text has been selected whilst viewing an external
source i.e. DVD or VCR. No text will appear on
screen or a box may appear stating no information
is available. Select a broadcasting channel and
press TEXT to access.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below.
LED indication
Condition
LED-2 LED-1
OFF Green (Solid) The TV is operatin
properly.
OFF Red (Solid) Standby with Power-
Green Red (Solid) Active standby
(Solid) (Digital mode)
OFF Red (Solid) Sleep timer
(Analogue mode)
OFF RED Blinks Power protect
0.5 sec cycle detection.
OFF Red Blinks Abnormal operation
1 sec cycle of BUS line.
OFF 2 times Abnormal operation
flashing with (Initialization error).
2 sec interval
Q
Why does the GREEN Active Standby LED
sometimes take longer to go out?
A
When put into standby the television's active
standby will automatically search all available
channels for downloads, provided Auto upgrade
is On. The time it takes to do this may vary.
Solution
–
–
On
–
–
Turn OFF the TV
and unplug the
power cord. Plug
the power cord in
again and turn ON
the TV.
LED-2 LED-1
Answers
Q
Why are the colours wrong when an NTSC
source is played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
EXT2
Store
OK
MENU
a
Set the Colour to Auto. and exit.
b
Go to the Picture settings menu and adjust the
tint.
Q
Why don't the devices connected via HDMI
operate properly?
A
Make sure to use cables with the HDMI logo
Some early HDMI equipment may not work
properly with the latest HDMI TV products, due to
new standard adoption. Unplug your HDMI cable
first and then try turning off the HDMI settings
(Deep Color, xvYCC, Lip Sync). Your early HDMI
source should operate properly with this television.
Q
Why don't the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed settings of
the device, turn off your television and unplug the
power cord, then plug and turn on again.
Unplug the HDMI cable of the REGZA-LINK device
and lead again.
Q
Why is the REGZA-LINK logo still showing
when the equipment has been disconnected?
A
If the REGZA-LINK is disconnected the logo will
disappear after approximately one minute.
45
continued
Manual setting
Colour system: Auto.
A V C R
Back Watch TV
EXIT
(see page 8).