Kingfisher HLXF10A3T41T Manual Del Usuario página 16

OPEN WINDOW
This function switches automatically to frost protection mode when an open
window is detected and returns to the initial mode when the window is
closed.
- Press MENU to display Πod, then press + to access
the Und menu.
- Press OK-boost to enter this menu.
- Press + or – to permanently activate the function
(Aut), or to activate it once (ΠAn) or to deactivate
it (OFF).
- Press OK-boost to validate.
The manual position (ΠAn) puts the heater into frost protection mode for
one hour. During this hour, the initial settings can be re-established by
pressing MENU.
The icon flashes when it detects an open window.
Important to note :
- The sensor in the heater detects whether a window is open or closed
by measuring abnormal temperature variations. Detection is carried out
several minutes after the window is opened or closed.
- Detection may be ineffective if these temperature variations are insuffi-
cient or untimely. This is the case where:
- The difference between the indoor and outdoor temperature is insufficient.
- The heater is too far from the window.
- The temperature gradient in the room does not allow for significant tem-
perature variations in the heater sensor.
- The ambient temperature is not stabilised at least one hour before the
window is opened.
- The temperature setting or mode were modified manually or by a pro-
gramme before or during detection.
DISPLAY OF REFERENCES
This menu displays the equipment and software
references (these references differ according to the
model).
- Press MENU to display Πod, then press + to access the references; the ref-
erence for the equipment and the reference for the software are displayed
alternately.
- Press MENU to exit the menu.
16
Quick start