Insert Film / Slides - AgfaPhoto AS1150 Manual Del Usuario

4 Wait until the control lamp h and STATUS
are no longer flashing and STATUS is contin-
ually on. This means that the scanning process
is completed and the data was saved onto the
memory card.
Notice
Removing documents from protective
cover
Remove the document from the pro-
tective cover after the scanning proc-
ess in order to avoid the document
sticking to the protective cover.

Insert film / slides

Notice
Suitable documents
• 35mm colour negative film
• Unframed slides
• 35mm black/white negative film
• Automatic rotating and mirroring of the
photo:
The scanner automatically recognises
the orientation of the negativ film when
the printed numbers on the edge are in
the same orientation as the photo. If the
numbering cannot be identified, this
function is deactivated.
Scanning documents with the protective cover
CAUTION!
Unsuitable Documents!
No glue residue or stickers should be
present on the edge of the negative.
Only unframed slides can be inserted.
CAUTION!
Damaged negative film ends
If the negative film ends are damaged
(not cut evenly, folded), cut the film
evenly and removed the folded corners.
1 Verify that there are not any documents in the
document feed. Push the document guide
rightmost.
2 Place the film guide on the designated grooves
in the document feed.
3 Carefully slide the film guide all the way into
the document feed. Be careful not to damage
the metal rails in the film guide.
4 When the film guide is inserted correctly, it
snaps into place and the device starts the cal-
ibration process.
5 Wait until the control lamps are no longer
flashing.
6 Remove the negative film/slides from the pro-
tective case/bag.
7 Verify that they are in the correct position for
insertion.
8 Hold the negative film such that the labelling
(number) of the negative is legible (not re-
versed) and the upper side of the image is fac-
ing in the direction of the activation key.
9 Insert the negative film / slide into the film
guide.
Notice
Handle the negative carefully
Handle the negative with care. If pos-
sible, wear cotton gloves.
10 Insert the negative film / slide into the film
guide far enough so that it is automatically fed
in and the scanning process starts. Be careful
not to bend the negative film / slide. The con-
trol lamp h flashes during the scanning proc-
ess.
Notice
Scanning speed
Due to the higher resolution when
scanning negatives / slides, the scan-
ning speed is slower than when scan-
ning photos.
11 Wait until the control lamp h and STATUS
are no longer flashing and STATUS is contin-
ually on. This means that the scanning process
is completed and the data was saved onto the
memory card.
12 Return the scanned negative film / slides to
the protective case / bag in order to avoid
damage or contamination.
13 The file name is assigned according to the DCF
(Design Rule for Camera File System) standard.
EN
7