Service; Cleaning; Calibrating The Scanner - AgfaPhoto AS1150 Manual Del Usuario

Service

Cleaning

DANGER!
Switching off the device!
Switch the device off using the h be-
fore you disconnect the USB cable or the
connection to the power supply.
Cleaning
DANGER!
Instructions for Cleaning!
Use a soft, lint-free cloth. Never use liq-
uid or easily
(sprays, abrasives, polishes, alcohol,
etc.). Do not allow any moisture to reach
the interior of the device. Do not spray
the device with any cleaning fluids.
Wipe over the surfaces gently. Be care-
ful that you do not scratch the surfaces.
Cleaning the feed rollers
1 Switch the device off.
2 Press and hold the h key until the control
lamp h light up.
3 The scanner is now in cleaning mode.
4 Push the cleaning sheet into the document
feeder.
Notice
Instructions for Cleaning
Observe the direction of feed. The
white sponge must be on the upper
side.
Do not use any cleaning agents or
cleaning fluids. Doing so can perma-
nently damage the feed rollers.
flammable cleansers
5 The sheet is automatically fed and the cleaning
process started. During cleaning, the control
lamps h and STATUS flash.
6 After cleaning is complete, the sheet is ejected
and the control lamp h goes out.
Notice
Cleaning sheet for the feed rollers
Store the cleaning sheet in a dust-
free location.

Calibrating the Scanner

A calibrattion of the scanner is necessary if the
scanned image looks blurred or has lines that are
not on the original. This allows you to adjust and
compensate for variations that can occur in the
optical component over time by its nature.
1 Clean the scanner glass first before calibrating
the scanner.
2 Insert a memory card which is not read-only
into the appropriate card slot at the rear of the
device.
3 Press the button h. Wait until the indicator
light STATUS is continually on.
4 Place the calibrating sheet in the document
feeder with the arrows facing the feed rollers.
5 The sheet is automatically fed and the calibra-
tion process started.
Notice
Calibrating the Scanner
Observe the direction of feed. If the
calibration sheet is inserted incor-
rectly, the calibration process cannot
be started.
6 After successful calibration, the sheet is eject-
ed.
EN
9