Morphy Richards TURBOSTEAM 40659 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
6
2
Wait for the temperature indicator
light to go out, then unplug the iron
and hold it about 6" (150mm) above
the sink in the ironing position.
3
Press the shot-of-steam button
about 10 times in succession.
4
Empty out any remaining water.
WARNING: Do not attempt to
descale the soleplate with
descaling products.
To clean a stainless steel
soleplate
(certain models only)
To keep the soleplate of your iron
clean and free of limescale,we
recommend that you use one of the
gentle chrome, silver or stainless
steel cleaners that are generally
available. Always follow the
manufacturers instructions. To clean
off melted man-made fibres set the
iron at 3 dot position and pass it
over a clean piece of cotton which
will draw the deposit off the surface.
To clean a coated
soleplate
(certain models only)
In the unlikely event of any man-
made fibre fusing to the soleplate,
set the iron at the 3 dot position and
pass it over a clean piece of cotton
which will draw the deposit off the
surface.
Do not use scouring powder or
solution as this could cause
damage to the coating.
To clean an aluminium
soleplate
(certain models only)
To keep the soleplate clean and free
of limescale, make a paste of mild
scouring powder and a little water.
Apply a small amount to the
soleplate, rub and then remove with
a damp cloth. Wipe thoroughly with
a clean cloth.
Exterior
Allow the iron to cool and wipe over
with a damp cloth and mild
detergent, then wipe with a dry cloth.
If your iron doesn't work
If the iron does not work, check the
following:
Has the temperature control been
set to the required temperature?
Is the plug in its socket?
Is the plug itself or the socket
faulty? Check by plugging in
another appliance.
YOUR TWO-YEAR
GUARANTEE
It is important to retain the retailers
receipt as proof of purchase. Staple
your receipt to this back cover for
future reference.
Please quote the following
information if the product develops
a fault. These numbers can be
found on the base of the product.
Model no.
All Morphy Richards products are
individually tested before leaving the
factory. In the unlikely event of any
appliance proving to be faulty within
28 days of purchase it should be
returned to the place of purchase
for it to be replaced.
If the fault develops after 28 days
and within 24 months of original
purchase, you should contact
Morphy Richards quoting Model
number and Serial number on the
product, or write to Morphy
Richards at the address shown.
You will be asked to return the
product (in secure, adequate
packaging) to the address below
along with a copy of proof of
purchase.
Subject to the exclusions set out
below (1-6) the faulty appliance will
then be repaired or replaced and
dispatched usually within 7 working
days of receipt.
If for any reason this item is
replaced during the 2-year
guarantee period, the guarantee on
the new item will be calculated from
original purchase date. Therefore it
is vital to retain your original till
receipt or invoice to indicate the
date of initial purchase.
Serial no.

Publicidad

Tabla de contenido
loading

Tabla de contenido