Morphy Richards SEMI-ELECTRONIC 40715 Manual De Instrucciones página 6

40715-40-41 inc AUS:9225 47507 MEE pump - Jon
Steam off
'MAX' steam
6
C C
FEATURES OF YOUR
IRON
Dry ironing
You can use your iron as a dry iron
only. Make sure the variable steam
control ⁄ is set to the '0' symbol.
Any temperature setting may be
used depending on the garment.
The spray feature may be used
provided there is water in the tank
D D
(see filling section). You do not need
to put any water in the tank when
dry ironing only.
Spray
C
Press the spray button ‹ and aim
the spray of water at stubborn
creases. You can do this whilst dry
ironing providing there is water in
the tank. When using the water
spray it may be necessary to push
the button a few times to get the
spray pump primed.
Variable steam
Fill the iron with water as described
in 'Filling', page 4 and insert the
plug into the electrical socket.
The steam output can be varied
from low to high by turning the
variable steam control D. When
E E
using the iron at the bottom of the
steam range, the steam output
should be adjusted to the low
setting.
The steam facility should only be
used on garments which are
suitable for ironing at 2, 3 dot and
MAX setting.
Shot of steam
Press the shot of steam button ¤
F F
to obtain a burst of extra steam for
ironing out creases in heavy
material such as denim etc.
The shot of steam can be used
whilst dry ironing, providing there is
water in the tank, and the
temperature control is set within the
steam range.
7/3/08 15:28
Do not use shot of steam at
temperatures below the steam
range shown on the control dial.
Note: For optimum steam quality,
do not operate the shot more than
three times in succession.
Vertical steam
Hold the iron in a vertical position
between 1cm and 2cm away from
the item F. Press the shot of steam
button ¤, this will create vertical
steam. This feature is especially
useful for removing creases from
hanging clothes, curtains, wall
hangings, etc.
Note; For optimum steam quality,
do not operate the shot more than
three times in succession.
No drip system
Your iron is fitted with a no drip
system which is designed to
prevent water escaping from the
soleplate when the iron is too cold.
During use, the no drip system may
emit a loud click, particularly during
heat-up or whilst cooling down. This
is perfectly normal and indicates
that the system is functioning
correctly.
Auto shut-off
Your iron is fitted with the auto shut-
off function it will automatically shut
down after a set period. The 'safety
switch off' led will flash on the
function panel.
If the iron is left unattended in the
horizontal position it will shut down
E after 30 seconds on certain models
and after 1 minute on models with
illuminated tanks.
If it is left in the vertical position it
will shut down after 8 minutes.
To reactivate the iron gently shake it
and wait for the iron to heat-up as
normal.
Page 6