ROC 350GB
18/07/02 11:33
If the B
B (18) key is pressed twice within one second, and is held down for more than 2 seconds the second time,
then the remote control will send the OFF code for all modes.
Since some satellite and cable receivers have no volume control, the
the television's volume in satellite or cable mode. For satellite systems with a volume control, it is possible to choose
the set that the MUTE (22) and VOL (20) keys will control in each of these modes: the television volume or the
volume of the satellite or cable receiver.
To choose, proceed as follows:
1. Press the TV key (the remote control must be in TV mode for this procedure).
2. Hold down the key S (7) until the red indicator lamp (4) remains lit (the indicator light
remains on for a few seconds to give you the time to proceed with the following steps.
The indicator lamp flashes to signal that this time is almost up, and then goes off).
3. Release the S key.
4. Press the MUTE (22) key for around 8 seconds. The indicator light will blink and
then go off for about 8 seconds before blinking once more and then staying off.
5. If the remote control previously controlled the television volume in SAT (MODE+)
mode, it will now control the volume of the satellite receiver; if it previously controlled
the volume of the satellite receiver, it will now control the television volume.
The THOMSON NAVILIGHT system allows you easy access to the settings of your
television (TV) or video recorder (VCR) including this feature.
1. Switch on the set you want to control.
2. Press the key corresponding to the type of set you want to use (TV, VCR or
MODE+). In the VCR position, make sure that the AV mode is activated for the TV
set (the SCART socket must be selected).
3. Press key MENU (3) once.
4. Navigate through the setting menus with the keys up, down, left, right
(1 and 17).
5. Validate with OK (2).
6. To leave the menus, press key EXIT (19) once.
Page 5
6 - Other function: All modes OFF
7 - Controlling volume in satellite and cable mode
8 - The NAVILIGHT system
remote control allows you to control
ROC 350
5