performing any type of maintenance on your
machine.
WARNING: Before performing any mainte-
nance or cleaning work, switch off the engine
and wait until the blade has come to a stop.
- Make sure that all nuts, bolts and screws are
kept well tightened to keep the lawn mower in
a safe operating condition.
- Never store the lawn mower with a tank with
gasoline in an enclosed area where gasoline
fumes could reach a strong heat source or a
flame. Allow the engine to cool down before
you store your lawn mower in any storage place.
- In order to reduce any risk of fire, clean the
lawn mower and in particularly the engine, the
muffler, the fuel tank. Suppress all grass traces
or leaves or excess of grease.
- Check frequently the condition of the deflec-
tor and the grass catcher, replace them if the are
damage.
- In case of drain oil of the tank before winter,
do this operation outside.
- Wear thick gloves for the mounting and the
sharpening of the blade. Be sure that the blade
is always well balance.
MAINTENANC
WARNING: stop the engine and unplug the
spark plug before any repairing or maintenance
operations.
Stop the engine and unplug the spark plug be-
fore any repairing or maintenance operations.
- For four strokes engine read carefully the
maintenance engine manual. Check regularly
the oil level and add some oil or replace it if
necessary.
- Frequently check the lawn mower and ensure
that all grass deposits are removed from be-
neath the deck.
- Lubricate regularly the wheel axle and the
bearings with grease.
- Check often the blade, in order to obtain a
clean work the blade should always be sharp
and well balance.
- At regularly intervals check the tightening of
all bolts and screws. Wear off or badly tighten-
ing nuts and bolts can involve some important
damages to the engine or the frame.
- If the blade hits violently an obstacle, stop the
lawn mower and bring it to agreed service sta-
tion.
THE BLADE: the blade is made of pressed steel,
in order to obtain a clean work sharpen the
blade frequently, around every 25 hours of
work. Be sure that the blade is always well bal-
ance, introduce a small iron axle( 2 or 3 mm)
E N G L I S H •
in the central hole of the blade, it should stay
horizontal .If the blade does not stay horizontal
balance it by taking off some metal on the side,
which is down.
YOU MUST ONLY USE THE MANUFACTURER
BALDE IT SHOULD BE REFERENCED AND WEAR
THE MANUFACTURER BRAND.
To remove the blade, unscrew the screw, check
the blade support and change all spare parts if
they are worn out or damage.
When reassembling the blade, make sure that
the cutting edges face in the direction of the en-
gine rotation. The blade screw must be torque
to 3.7 K· gm (37 Nm) with a dynamometric tool.
ONLY USE ORIGINAL SPARE PARTS. SPARE PART
OF BAD QUALITY CAN INVOLVE IMPORTANT
DAMAGES TO YOUR LAWN MOWER AND BE
PREJUDICIAL FOR YOUR SECURITY.
WARRANTY CONDITIONS
The manufacturer warrants the product 12
months from the date of purchasing, from
all fabrication faults. The lawn mowers that
are used in a professional or locative way are
warranted 3 months. The warranty cannot be
claimed in case of normal wear.
The manufacturer will replace at his expense the
spare parts, which would be classified as defec-
tive by him or an agreed station service. In any
case the manufacturer will not accept the reim-
bursement of the machine (partially or totally)
and/or damages and interest direct or indirect.
The warranty does not cover:
- An insuffisant maintenance.
- An abnormal use or damage due to shocks.
- The mounting, adjustment and preparation of
the machine.
- The spare parts with normal wear, security
spare parts (belt, blade, blade support, bearings,
cables, deflectors, spark plug, air filter etc...)
- Freight and packing cost.
The manufacturer will refuse any responsibility
if the machine was not used for the purpose
it was made or if the operator did not use the
machine as describe in the operations and main-
tenance rules in the owner manual.
Read carefully the instruction manual before
any use of the lawn mower.
For all spare parts order you must specify the
reference of the mower the construction year,
the serial number of the mower and of the en-
gine.
Us er 's M an u a l
11